763339
20
Zoom out
Zoom in
Previous page
1/146
Next page
18
Hanger with Roll & Press system assembly
1. Unscrew the hanger fastening screw at the bottom of the hanger (fig. 7).
2. Hold the hanger such that the Roll & Press system handle is on the same side as the locking
hook.
3. Insert the hanger vertically on the top of the pole. The holes at the bottom of the hanger and
in the pole should be at the same level (fig. 8).
4. Put the screw back and screw in as far as it will go so that the hanger is firmly fixed to the
pole (fig. 9).
5. Install the steam head between the hanger hooks.
2 • Filling the water tank
IMPORTANT: Your product is designed to operate using untreated tap water. If your water is
very hard (check with your local water authority) it is possible to mix untreated tap water with
store-bought distilled water in the following proportions 50% untreated tap water with 50%
distilled water. Heat concentrates the elements contained in water during evaporation. The
types of water listed below may contain organic waste, mineral or chemical elements that can
cause spitting, brown staining or premature wear of the appliance: water from clothes dryers,
scented or softened water, water from refrigerators, batteries, air conditioners, rain water,
boiled, filtered or bottled water. These types of water should not be used. Only use store
bought distilled water as advised above.
• Ensure that the steamer is unplugged. Remove the water tank from the base of the appliance
by pulling the handle upwards (fig. 10). Unscrew the tank cap and fill the tank (fig. 11).
Maximum capacity is indicated by the “max” mark.
After closing the cap, turn the tank down and hold it by the handle. Check that no water is
leaking through the cap.
• Place the water tank on the base (fig. 12).
USE
WARNING: Never steam a garment while it is being worn.
The flexible pipe and the end of the steam head can become extremely hot during
use. This is perfectly normal. Be careful and avoid any prolonged contact.
1 • Setting up
• Only operate the steamer on the floor clear of any materials which may obstruct the base
of the steamer, ensure the floor is dry, flat, stable and heat-resistant. Do not obstruct the
openings on the lower part of the appliance. This device should not be used on very thick
carpets or rugs.
• Undo the Velcro strip and completely unwind the electrical cord.
• Plug in to power socket (fig.13).
• Switch on by pressing the pedal located at the front of the device. The power indicator light
will come on (fig.14).
The device will begin producing steam after approximately 60 seconds.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta IS6350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta IS6350 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 8,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info