739334

Rowenta DG8020 Manual

7
Zoom out
Zoom in
Previous page
1/46
Next page
11 • Cleaning the generator
The Iron soleplate: You can clean the
soleplate of your iron, once it has cooled down,
with a damp cloth or sponge.
The base unit: Clean the plastic parts of the
appliance occasionally with a soft cloth.
12 •
Rinsing the boiler
Your generator is equipped with an orange
“boiler rinse” warning light (fig.9) that flashes
on the control panel after about 10 uses.
You can continue ironing normally but
remember to rinse the boiler first, the next
time that you use it.
Before attempting to rinse the boiler of your
generator, it is essential to leave it to cool for
at least 2 hours in order to avoid any risk of
scalding.
Place your steam generator on the edge of your
sink, with the iron to one side, standing on its
heel. Remove the boiler rinse cap cover (fig.14).
Using a coin, gently unscrew the boiler rinse cap
(fig.15).
With the rinsing accessory
: it will make it
easier to rinse the boiler as the generator will
need less handling. Your rinsing accessory has
been designed to work on a wide range of taps.
Choose the one best suited to your tap (a or
b)(fig.16). Place the plastic nozzle of the
rinsing pipe into the hole of the boiler and turn
gently to the right until it locks (fig.17). The
outlet of this nozzle must be positioned over
the sink (fig.18). Connect the rubber end ¡ of
the rinsing pipe to a cold tap (R). Turn the tap
on gently and gradually and let cold water run
through the rinsing pipe into the sink for about
1 minute (fig.19). Switch off the tap and
remove the rinsing pipe.
Or
With the rinsing accessory
:
Gently unscrew the boiler rinse plug (fig.14).
Holding your steam generator in a tilted
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of tap water.
Shake the base unit for a few moments and
then empty it completely over your sink.
To obtain the best result, we recommend that
this operation is done twice.
ATTENTION: Do not use descaling agents
for rinsing out the boiler, as they could
damage it.
Do not use any cleaning or descaling
products for cleaning the soleplate or the
base-unit. Never hold the iron or the base
unit under the tap.
MAINTENANCE AND CLEANING
Before cleaning or rinsing the boiler, ensure that the appliance is unplugged and that the
soleplate and the iron rest have cooled down for at least 2 hours, in order to avoid any risk
of scalding.
The next time you use the generator, hold
down the “restart” (fig.20) button to turn
off the orange light. .
Close the water tank. Press on the on / off
switch (fig.4). It is flashing. Press the “Restart”
button. The generator and the iron are ready to
iron when the steam ready indicator light is lit
and the iron thermostat dial light has gone out.
10 • Storing your generator
Press the illuminated on/off switch O/I and
unplug the generator. Place the iron on the iron
rest plate. Press the cord reel button (depen-
ding on model) and guide the cord with your
hand (fig.12) and store the steam cord.
Leave the iron to cool down for 1 hour before
putting it away if it is stored in a cupboard or
confined space.
GB
7
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta DG8020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta DG8020 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 6,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info