712124
44
Zoom out
Zoom in
Previous page
1/48
Next page
44
Crema is not perfect?
Finding Possible cause
not enough crema
powder is too coarse, powder is not compressed enough, beans are too old, cup
or machine is dirty.
crema is too dark beans are too old, powder is too coarse, powder is not compressed enough.
crema is too light beans are too old, powder is too coarse, powder is not compressed enough.
crema is not firm cup is too cold or too hot, water pressure is too low.
First aid ...
Finding Cause and troubleshooting
Permanent glowing
pilot lamp in red
No fault
Heating-up period of the thermoblock!
Quickly blinking
pilot lamp in red
Thermoblock too hot after steam supply
For cooling down the system, choose the function “espresso/hot water“. Turn the
rotary knob to the right. Dispense hot water for 10 seconds.
Slowly glowing
pilot lamp in blue
No fault
Power save mode without heating is active! To activate the appliance, press the
“1 cup“ or “2 cup“ switch!
Permanent glowing
pilot lamp in blue
No fault
Appliance is ready for use!
Quickly blinking
pilot lamp in blue
Water tank is empty
Switch the appliance off. Refill the water tank; afterwards bleed the system by
dispensing hot water!
Water tank is not inserted correctly
Switch the appliance off. Insert the water tank as far as it will go on the gasket,
afterwards bleed the system by dispensing hot water!
Water filter is blocked
Switch the appliance off. Remove the water filter from the tank and start dispen-
sing water without filter. If the supply is ok, the water filter must be exchanged.
Water filter is not soaked enough
Switch the appliance off. Lay the water filter in water for at least 15 minutes,
afterwards insert it according to instructions!
Blocked filter insert
Switch the appliance off. Clean the filter insert thoroughly, clean sieve and holes
carefully with the cleaning pin if necessary!
Quickly alternate blinking
of the pilot lamp
Rotary knob is not in position “0“ or “hot water/steam“
Switch the appliances off, position the rotaty knob to “0“ and switch the appli-
ances on again!
pump generates loud pump noise
water tank is empty during hot water/steam supply
Switch the appliance off. Refill the water tank, afterwards bleed the system by
dispensing hot water!
milk froth is not satisfying
milk is too warm
Use refrigerated milk!
unsuitable vessel
Use a suitable stainless steel pot!
nozzle holes are blocked
Clean the nozzle thoroughly!
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rommelsbacher EKS 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rommelsbacher EKS 2010 in the language / languages: English, German as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info