622366
7
Zoom out
Zoom in
Previous page
1/24
Next page
7
Front and Rear Panels
Front Panel
fig.1
In some cases, it may be possible to make settings on the device connected via
R-BUS to disable front panel operations.
1 PHANTOM Buttons 1–8
When connecting the XLR input jack to a device that requires phantom power, turn this
on. When phantom power is being supplied, the PHANTOM indicator will light.
Supplying phantom power to a dynamic mic or an audio playback device
will cause malfunctions. Carefully read the owner’s manual of the device you
are using, and leave this turned off except when connecting a device that
requires phantom power (such as a condenser mic).
When phantom power is turned on/off, high-volume noise may be output,
which can damage your amp or speaker system. Be sure to turn down the
volume of audio equipment before you turn the phantom power on/off.
Turn phantom power off if nothing is connected to the XLR input jacks. Also,
to minimize noise, we recommend that you make the PAD indicator light and
turn the INPUT knobs that adjust the input sensitivity all the way to the
“+4dBu” position.
2 PAD Buttons 1–8
Switch the input sensitivity (adjustment range of the INPUT knob) for INPUT1–8.
When the PAD indicator is lit: +4 dBu– -44 dBu
When the PAD indicator is dark: -16 dBu– -64 dBu
3 PEAK Indicators 1–8
This will light when the input level of INPUT1–8 is excessive.
The PEAK indicator will light at the level at which the waveform clips (distorts). The
ideal level is when the sensitivity is raised as far as possible without causing the PEAK
indicator to light. If you wish to make more precise adjustments, watch the level meter
of the device connected via the R-BUS connector as you make adjustments.
4INPUT Sensitivity Knobs 1–8
Adjust the input sensitivity for INPUTs 1–8.
If you rotate the knobs, or push the PAD buttons while the MANUAL indicator is
lighted, the value currently indicated by the knob will be put in effect. Previous values
will remain in effect for knobs left untouched.
1
2
3
4
5 7 8
6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roland ADA-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roland ADA-7000 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info