168917
29
Zoom out
Zoom in
Previous page
1/32
Next page
29
5. CROSSOVER SETTINGS
5.5 ADJUSTING INPUT SENSITIVITY
To reach a maximum noise-free dynamic headroom from each
individual head unit/amplifier/speaker combination, it is impor-
tant to set the respective input gain controls correctly. The input
level settings determine the actual signal-to-noise ratio, and they
are also responsible for obtaining the maximum distortion-free
SPL (sound pressure level) from your specific setup.
Turn-on your head unit and set the volume control to approxima-
tely 3/4 of full volume, while playing a dynamic track from a CD.
Slowly increase the LEVEL adjustment control of the channel pair
section to which your subwoofer system is connected to. Turn
up the (sub channel) level control knob until you can just about
hear distorted bass sounds. Now you reduce the volume level
of your head unit to a “normal” listening level and “add” all the
remaining channel pairs, but turning up the corresponding level
controls – aiming for a balanced sound with a slight emphasis
of the bass range. All remaining channels, no matter if this con-
cerns rear mounted coaxials, component- or kickbass systems
installed in the front doors – must be balanced against the main
level setting of your subwoofer. Usually, it’s best to start with the
level adjustment of the front door mounted speaker system.
5.6 ADJUSTING THE BASS EQ CONTROL
The bass EQ control of your RODEK amplifier can be adjusted
with the e-pot to “push” the 45 Hz center frequency from 0 dB
to 10 dB. The bass EQ will increase the perceived low end re-
sponse of your amp woofer combination – but it will also reach
the max. output of the respective channel earlier. With a bass
EQ adjusted too high, most speakers can be overdriven easily.
Thus, this setting should be attempted with care.
NC-Amp 1-2-4-5-CH Manual_D+E_pfade.indd 29 09.05.2009 11:25:33 Uhr
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rodek rn 1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rodek rn 1600 in the language / languages: English, German as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info