168160

Rodek ri 4100 Manual

29
Zoom out
Zoom in
Previous page
1/40
Next page
29
3. MOUNTING OF THE AMPLIFIER
3.2 MINIMUM IMPEDANCE LOAD
The output stages of the RODEK amplifiers are designed to
give you extraordinary output power into 4 and 2 ohms loads in
normal stereo configurations. In bridged mode, the minimum
impedance load is 4 ohms. The amplifier might suffer from ther-
mal shut-down or even damage, if these recommended minimum
impedance load ratings are not considered appropriately. The
RI-1650D can drive subwoofers down to 1 ohm impedance.
3.1 MOUNTING LOCATION
The mounting location should be carefully selected, preferably
in the trunk compartment of your car! In the interest of passive
driver and passenger safety, the amplifier must be securely
mounted, and special precautions must be taken to allow suf-
ficient cooling. The amp can get quite hot during operation, so
a clearance of at least 10cm from both sides and from the top
of the amp must be considered.
Make sure there is no wiring harness, fuel tank etc. behind or
below the mounting surface that may be damaged by the dril-
ling of the holes for the amplifier mounting screws. The above
mentioned clearance of at least cm to all sides of the amplifier
is not only for proper cooling, but also because the crossover
controls must remain accessible.
The amplifier must NOT be mounted directly to the chas-
sis ground of the vehicle, this may cause to ground loops
with loud hum noise.
FRONT PANEL
RI-1650D
REAR PANEL
RI-1650D
5 6 7 8 91 2 3 4 bl bm
bn bo bp bq br
RI-Amp 1-2-4-CH Manual_D+E.indd 29 05.01.2008 12:33:13 Uhr
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rodek ri 4100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rodek ri 4100 in the language / languages: English, German as an attachment in your email.

The manual is 5,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info