4.3.5 Near Wire Follow
In the Main Zone, when Robomow completes its operation, or when the Home button instructs it to Go To Base, it drives
itself to the Base Station.
Robomow drives along the Perimeter Wire with a dynamic offset (not centered) to prevent wheel tracks along the same
path. This return behavior can be turned off.
The offset Distance values range from 1 to 12. They represent
different distances from the wire.
The higher the Distance setting, the smaller the probability of tracks
along the perimeter.
4.3.6 SmartMow
P The unique SmartMow feature allows more efficient mowing
operation through the smooth and continuous turns when
reaching lawn’s edge.
P When this feature is enabled for the first time in a particular
zone, it may require the mower to cross the lawn and “touch”
the perimeter wire several times (to perform an initial calibration
of the algorithm), before it will start performing smooth turns at
lawn’s edge.
P Edge Overlap allows adjusting the degree of overlapping with
lawn’s edge, when performing the smooth and continuous turns
in SmartMow mode.
P Increasing this value will cause a higher overlapping with lawn’s
edge (for better mowing results), but at some point may prevent
the mower from performing a smooth turn.
Press to select On/Off.
Scroll to select All Zones / By Zone. If By Zone
is selected scroll to select Zone. Press
.
Scroll to select On/Off.
Scroll to set the Edge Overlap value. Press .
Press
to select Near Wire Follow from the
Lawn Options menu.
Press
to select On/Off.
Scroll to select All Zones / By Zone. If By Zone
is selected scroll to select Zone. Press
.
Scroll to select On/Off.
Off = Robomow will drive centered along the wire.
Scroll to set the maximum value for the Distance
Robomow drive from the edge. Press .
Scroll to select Distance Press
