If the passage is WIDER than 1.5m:
If the Narrow Pass is wider than 1.5m (5 ft.), and you want Robomow to
mow the area inside the Narrow Pass, set the wire as shown in the figure
below. This setup allows the mower to mow inside the Narrow Pass while
mowing the inner part of the lawn, but prevents it from crossing between the
zones.
1. Define the entry to the Narrow Pass – the point at which the mower will
start driving towards the Sub-Zone.
2. Set a Perimeter Island in the middle of the Narrow Pass (refer to 2.2.1)
as shown in the picture above and maintain 14 cm (5.5 inches) from the
Perimeter Wire.
3. The island dimensions should be 32 cm (12”) along the side and as
wide as needed, keeping 14 cm (5.5 inches) from both sides.
4. After completing the setup of the wire in the Sub-Zone, make sure to
keep 14 cm (5.5 inches) between the wire and the island on the way
back to the Main Zone.
