512474

Robomow RM200 Manual

15
Zoom out
Zoom in
Previous page
1/44
Next page
15
1.3.2 Laying Out the Perimeter Wire
Start setting the perimeter wire by placing pegs every few meters and at the lawn corners according to
your plan; do not forget obstacles that need to be demarcated while laying the wire.
After removing enough wire within a given section, use the RoboRuler provided to set the correct distance
from the lawn edge. The RoboRuler is used to help position the perimeter wire along walls, fences,
sidewalk, driveways, flowerbeds and other perimeter zones.
There are two basic measurements that are used on the RoboRuler (Figure 1.12).
The shorter distance is used along perimeter edges where the area outside the immediate perimeter is
free of obstacles and is the same relative height as the perimeter edge or lower (sidewalk on the same
level or flowerbeds).
The longer distance is used along perimeter edges where the area outside the immediate perimeter has
obstacles or differences in the height along the perimeter edge (walls and fences).
Important
If the lawn's edge borders with a pond, swimming pool or watercourse or where the grass level is higher
than 70cm (2ft) from the edge around it, then it is required to keep a distance of at least 1.2m (4ft)
between the wire and the water (or chasm) otherwise supplement a fence or the same along the lawn's
edge, so Robomow can detect it. The height must then be at least 15cm (6 inch). This will prevent
Robomow, under any circumstances, from crossing the wire outside the working area
1.3.3 Fastening The Wire To The Ground
It is not necessary to bury the perimeter wire, though you may do so if you wish, up to 10 cm
(4 inches) deep.
Small pegs or stakes are supplied with the Robomow and they are used to fasten and hold the
perimeter wire to the ground, below grass level.
Initially place a minimum number of pegs to fasten the wire down. Remember that you will want to test
the wire set up before you fill in additional pegs and you may find some areas where you will need to
move the wire position slightly.
Upon hammering the peg to its final depth in the ground, pull the wire tight. It is a lot easier to insert
pegs into wet soil. If the soil is dry, water the yard before perimeter wire set up.
WARNING!
Damage to the eye is possible. Use proper eye protection and wear
appropriate work gloves when hammering the pegs. Hard or dry ground
may cause pegs to break when driving them in. In extreme cases,
watering the lawn where the pegs will be driven can be beneficial.
Short distance of RoboRuler
– where the area outside
the immediate perimeter is
free of obstacles and is the
same relative height as the
perimeter edge or lower
Long distance of
RoboRuler – where
the area outside the
immediate perimeter
has obstacles or
differences in the
height along the
p
erimeter ed
g
e
Figure 1.12 – using the RoboRuler
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RM200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RM200 in the language / languages: English as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RM200

Robomow RM200 User Manual - German - 44 pages

Robomow RM200 User Manual - Dutch - 44 pages

Robomow RM200 User Manual - French - 61 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info