512470
69
Zoom out
Zoom in
Previous page
1/84
Next page
Chapter 8-7
Troubleshooting
Problem Encountered Probable Cause/Event Corrective/User Action
Operation
Robomow will not operate and
nothing will display on the LCD
screen.
- Mower is in deep sleep.
- If not connected to the charger at all times when
not in use, the Robomow will conserve power by
entering into a deep sleep mode. Lift Power Pack
from mower and re-insert it after 10 seconds.
- Power Pack has been discharged from
lack of charge maintenance.
- It is required for the charger to remain connected
to the Robomow when not in use. Failure to do
so can cause permanent Power Pack damage.
Contact your service provider.
Robomow drives but blades will
not mow.
- ‘Mowing’ has been turned to off. - Change back on under ‘User Preferences’
Short run time, operates less
time than normal.
- Power Pack is not fully charged
- Connect the charger to the mower and keep it
connected until the ‘Ready – Keep Charging’
message displays in the LCD screen.
- ‘Work Time ‘ for that zone is set to stop at
a pre-determined duration.
- Work time can be changed under ‘User
Preferences’
- Grass is extremely over grown or very
wet.
- Raise cutting height. Always mow the grass
frequently enough to prevent over growth. Refrain
from cutting wet grass.
- Power Pack is reaching a normal end of
life state.
- Replace Power Pack. Properly maintain Power
Pack per instructions.
- Manual Controller is not firmly pivoted
down flush in holder, allowing it to bounce
up and stop the mower.
- Confirm the coiled cord is fully placed into the
holder below the Manual Controller and the Manual
Controller closes flush with the top of the mower.
Robomow has crossed over
wire during operation
CAUTION The Robomow is
designed to remain within an
active perimeter of your lawn
when properly installed. In
the unlikely event that the
mower does cross over the
wire, DO NOT use the mower
until the problem is corrected.
If changing the perimeter wire
placement does not correct this
problem, contact you service
provider.
- Improper perimeter wire setup OR
adjacent zone (closer than 13 feet / 4 m)
operated simultaneously.
- Refer to the setup rules for wire placement,
particularly for corners. Do not operate adjacent
plots simultaneously when closer than 13 feet (4
m).
Robomow does not complete
the edge in a non-docking zone.
Peculiar geometry of perimeter Perform ‘Learn Edge’ (refer to 7.2.1 Chapter 7-4).
The Robomow gets stuck fre-
quently when traveling over less
than optimal terrain.
Low ground clearance. Raise ground clearance to the uppermost position.
Cutting height too low. Raise cutting height
Terrain needs landscaping repairs.
Fill in all holes, cover or exclude all exposed roots etc in
order to smooth the terrain.
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RL serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RL serie in the language / languages: English as an attachment in your email.

The manual is 19,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RL serie

Robomow RL serie User Manual - German - 84 pages

Robomow RL serie User Manual - Dutch - 84 pages

Robomow RL serie User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info