512470
68
Zoom out
Zoom in
Previous page
1/84
Next page
Chapter 8-6
Robomow RL555, RL855, RL2000
Problem Encountered Probable Cause/Event Corrective/User Action
Perimeter Switch / Perimeter Switch
‘Cut wire’ indicator flashing on
Perimeter Switch or on Base
Station
- Wire disconnected from switch
- Confirm wire is plugged in and wire leads are firmly
attached
- Perimeter wire cut
- Walk along perimeter, including islands and
obstacles excluded with the perimeter wire and
look for obvious cuts or breaks in the wire. Repair
with Robomow wire splice connectors.
- Poor connections
- Check and repair all loose/poor or corroded
connections
‘Poor connection’ indicator
flashing on Perimeter Switch
or
the Base Station beeps intermit-
tently for poor wire splicing or
too long
- Twisted cables, or a screw terminal,
insulated with insulation tape is not a
satisfactory splice. Soil moisture causes
the conductors to oxidize and after a while
result in broken circuit.
- Use the connectors supplied in the box. It
is waterproof and gives a reliable electrical
connection.
- Perimeter wire is too long for one zone
- A maximum perimeter wire length of 500 m is
recommended. Areas requiring longer lengths
should be broken into separate zones.
Perimeter Switch will not
activate when turned on.
- Power Supply is not connected
- Confirm power supply is plugged into the main
power receptacle, re-connect the plug to the
Perimeter Switch and confirm the ON is blinking.
- Batteries are completely discharged. - Install fresh alkaline C-cell batteries
- Perimeter Switch not installed vertically
and exposed to water/rain.
- Water/moisture protection of the Perimeter Switch
can only be insured when mounted vertically.
Replace Perimeter Switch.
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RL serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RL serie in the language / languages: English as an attachment in your email.

The manual is 19,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RL serie

Robomow RL serie User Manual - German - 84 pages

Robomow RL serie User Manual - Dutch - 84 pages

Robomow RL serie User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info