512470
65
Zoom out
Zoom in
Previous page
1/84
Next page
Chapter 8-3
Troubleshooting
Message
Displayed
Probable Cause/Event Corrective/User Action
F
- Internal bumper failure - Contact service provider
Front/Rear bum-
per disc.
Front/Rear bum-
per pressed
- Front or Rear Bumper is constantly being
pressed
- Move mower away from object pressing against
bumper.
Front Wheel Prob-
lem
- The Front Wheel has left the ground for more
than 8 – 10 seconds.
CAUTION – Remove power pack before lifting the mower
- The Robomow has driven onto an obstacle, raising
the front end. Remove or exclude this object from the
mowing area.
- The Robomow is being used on a slope too steep for
safe mowing. Exclude this from the mowing area.
- High grass is preventing the front wheel from fully
riding on the ground. Raise the cutting height.
- The ground contains large holes or indentions where
the front wheel can drop into when passing across.
Fill these areas with dirt and level off.
H
- Robomow is charged through the plug and
ambience temperature is out of range (above
158ºF / 70ºC)
- Robomow charging is not allowed when the
ambience temperature is raised above 158ºF /
70ºC; Disconnect the charger plug and wait until the
temperature will go down or take the Robomow to be
charged in a cooler place.
High temp.
Disc. charger
High temp.
Waiting…
- Robomow is charged through the Base Station
and the ambience temperature is out of range
(above 158ºF / 70ºC);
- Do not do anything, the charging is stopped and
Robomow is waiting for temperature to change back
to the allowed range; if temperature stays out of
the range for more than 12 hours, the message is
changed to ‘High temp. Press

.
K
- Message is displayed every time the charger
plug is disconnected from the mower.
- Displayed when the mower isn’t in operation and
not connected to the charger/Charging for a long
time.
- Press any key to change the display back.
- Send the mower back to the Base Station for
charging / connect the charging plug or continue in
operation
Keep charging if not
used
Keys locked
- Child lock feature has been activated
- Press the Up arrow key and then press the
button. Child lock can be deactivated under User
preferences.
L
- Mower is searching for the Base Station but
the battery voltage is too low to continue the
searching process
- Drive the mower manually for charging in the Base
Station
Low battery
Low temp.
Disc. charger
- Robomow is charged through the plug and
ambience temperature is out of range (below 32
ºF / 0 ºC); disconnect the charger plug from the
Robomow.
- Robomow charging is not allowed when the
ambience temperature is going down below 32ºF /
0ºC; Disconnect the charger plug and wait until the
temperature will go up or take the Robomow to be
charged in a warmer place.
Low temp.
Waiting…
- Robomow is charged through the Base Station
and the ambience temperature is out of range
(below 32ºF / 0ºC);
- Do not do anything, the charging is stopped and
Robomow is waiting for temperature to change back
to the allowed range; if temperature stays out of
the range for more than 12 hours, the message is
changed to ‘Low temp. Press

.
Left/Mid/Right mow
problem
- Mowing motor is faulty or disconnected - Contact service provider
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RL serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RL serie in the language / languages: English as an attachment in your email.

The manual is 19,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RL serie

Robomow RL serie User Manual - German - 84 pages

Robomow RL serie User Manual - Dutch - 84 pages

Robomow RL serie User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info