512470
22
Zoom out
Zoom in
Previous page
1/84
Next page
Chapter 2-6
Robomow RL555, RL855, RL2000
P Insert the pegs at distances that will keep the wire down below the grass
level and prevent the wire from becoming a tripping hazard
P The wire and the pegs will soon become invisible under the growth of
new grass.
P If additional wire is required in order to complete the setup, connect it
using the water-proof wire connectors supplied with Robomow. (Refer to
paragraph 10.7 – Splicing the Perimeter Wire).
c IMPORTANT c
Use only the wire connectors supplied with Robomow.
Neither Twisted cables, nor a screw terminal insulated with insulation tape
are a satisfactory splice.
Soil moisture will cause such conductors to oxidize and which later leads to
a broken circuit.
2.4 Back at Base Station – Completing the Perimeter Wire
setup
Once the Perimeter Wire loop is completed and pegged to the ground, you
complete the setup by attaching the beginning and end of the Perimeter
Wire to the Base Station board.
P Hold both ends of the Perimeter Wire: the wire that started the loop is
the one with an attached connector.
P Trim the end without the connector to make both of equal length.
Remove any excess wire and Strip back 5 mm (0.2 inches) of insulation
from the wire end.
P Peg the two perimeter wires down to the ground using the same peg
leaving enough loose wire.
Twist together the two loose parts.
P Thread the two twisted wire ends through the center aperture in the
Base Station.
P Insert the end of the wire without the connector into the hole of the other
wire’s connector. Use a small flat screwdriver to tighten and secure this
wire into the connector.
















22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RL serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RL serie in the language / languages: English as an attachment in your email.

The manual is 19,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RL serie

Robomow RL serie User Manual - German - 84 pages

Robomow RL serie User Manual - Dutch - 84 pages

Robomow RL serie User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info