512470
21
Zoom out
Zoom in
Previous page
1/84
Next page
Chapter 2-5
Base Station and Perimeter Wire Setup
2.2.3 A pond, swimming pool, or watercourse at lawn’s edge
OR:
Grass level more than 70 cm (2 ft) higher than outer area.
P Set the Perimeter Wire at least 1.2 m (4 ft) from the water (or chasm).
P You may provide a fence or another barrier along the lawn’s edge by the
water, so Robomow will surely detect it.
) The barrier should be at least 15 cm (6 inch) high. This will
block Robomow, under all circumstances, from crossing
over the Perimeter Wire into the water area.
) If such a barrier exists, you may set the Perimeter Wire at
the Long Distance of 45 cm (18 inches) from the barrier.
2.2.4 Slopes
Perimeter slope
P If a slope is steeper than 15 cm rise per 1 meter (0.5 ft rise per 3.3 ft),
do NOT lay Perimeter Wire over it.
) However, if there is a barrier (e.g. fence, wall, or hedge) that
can protect the mower from sliding off, the Perimeter Wire
can be set on that slope.
In-lawn slopes
P Robomow can mow areas that have less than a 27% slope
(roughly 27 cm per 1 meter / 0.9 ft rise per 3 ft).
P Tip: If Robomow tilts off the ground while climbing a slope, it is
too steep.
Exclude this steep area from Robomow’s cutting area.
2.3 Fastening Perimeter Wire to the Ground
P It is not necessary to bury the perimeter wire, though you may do so, up
to 10 cm (4 inches) deep.
P Upon hammering the peg to its final depth in the ground, pull the wire
tight.
WARNING!
Protect your eyes!
Protect your hands!
Use proper eye protection and wear appropriate work gloves when
hammering the pegs. Hard or dry ground may cause pegs to break
when driving them in.
Watering the lawn where the pegs are to be inserted can make
your work safer.
Introduction
Introduction 7
What’s in the Boxes
1
Robomow
®
9
Base Station wheel supports Used
for supporting Robomow drive
wheels when entering and departing
the Base Station.
17
Wire connectors
Used for splicing wires (as
needed).
2 Power Pack 10
Screws x2
Used for assembling the Base
Station wheel supports to the Base
Station.
18
Plot connector
Used for connecting the completed
perimeter wire set-up to the
perimeter switch/Base Station.
3
Perimeter Wire
Used to create a virtual wall for your
Robomow.
11
Extension cord (15meters low
voltage cable)
19
Screws x2
Used for assembling the Base
Station Cover to the Base.
4
Pegs - Used for securing the wire to the
ground.
12 Indoor Power Supply 20
Power Supply holder (+ screws
and dowels) Used for fixing the
Power Supply to a wall.
5 Assembled Base Station. 13
Base Station Stakes - Used for securing
the Base Station to the ground.
21
Perimeter Switch
6
Base Station Cover
Used for recharging the Robomow Power
Pack and activates the perimeter wire.
14 Operating & Safety Manual 22
Perimeter Switch Stake - Used to
hold the perimeter switch vertical to
the ground.
7
Base - Used for directing the Robomow
to the charging contacts.
15 DVD – Setup and Operation video. 23
Power Supply for Perimeter
Switch – Used for operating the
perimeter switch. Batteries
available as an accessory
8
Charging Fence
Used for preventing the Robomow to
climb on the Base Station during
operation.
16
RoboRuler
Used for setting the distance of the
perimeter wire from the lawn edge.
24
Power Supply
(for charging Robomow)
2
1
3
4
5
6
7
8
9
11
12
13
15
10
19
17
18
20
RL2000 ONLY
14
21
22
23
24
16
RL555/855ONLY
At least
1.2 m (4 ft)
At least
45 cm (18”)
27 cm
(0.9 ft)
Max 27% slope
(15º degrees)
1 meter (3.3 ft)
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RL serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RL serie in the language / languages: English as an attachment in your email.

The manual is 19,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RL serie

Robomow RL serie User Manual - German - 84 pages

Robomow RL serie User Manual - Dutch - 84 pages

Robomow RL serie User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info