625584
55
Zoom out
Zoom in
Previous page
1/98
Next page
54 V0114 SD410 - S410
Nederlands Français English Deutsch
Maintenance of the machine
Warning: always disconnect the machine from its power supply before starting all maintenance works!
The interior parts of the machine must be cleaned regularly in order to avoid accumulation of dust and
woodchips.
Any possible deposit of resin, on the various parts of the tables, must be taken away with a piece of
cloth and a little bit of solvent. Never smoke or have any naked ame near the machine when using
ammable products, avoiding the risk of re and serious burns for the operator!
The machine parts which need maintenance are the planer hinges and axis. They must be lubricated
on a monthly base using a thin oil such as WD-40.
The life of the motor can be extended by removing the saw dust from the cooling fan and the motor by
using a dust extractor.
All bearings inside the machine are double sealed and lubricated for life, therefore they need no
maintenance.
Adjusting the engine brake
If the run down time of the motor exceeds 10 seconds, the brake will need to be readjusted.
This is done as follows: without removing the motor cowling, turn the bolt holding the ventilator fan on
the motor axle one 1/16 of a turn clockwise and make a brake test.
When needed adjust the brake furthermore until it does not exceed 10 seconds.
The air gap between ventilator fan (brake disk) and brake liner (Ferrodo) is factory set at 0.25 mm.
1 Moot frame
2 Key
3 Spring
4 Motor axle
5 Air gap
6 Electromagnet
7 Mobile disk
8 Locking nut
9 Adjustment bolt
10 Washer
11 Braking disk cast iron
12 Brake liner (Ferrodo)
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland S410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland S410 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info