-E6- -E7-
NOTE: Never turn on the fryer with an empty Oil Reservoir.
Always use your fryer on a flat, heat resistant surface.
1. Attach magnetic end of SureRELEASE
TM
cord
assembly directly to the fryer. This should be
done prior to plugging the cord into the
wall outlet (See Figure 2). The magnetic end
of the cord is designed only to go on one way. Be
sure the side stating “THIS SIDE UP” is facing up.
2. Unlock Lid by pressing the Open Lid button. To remove Frying
Basket, pull handle up until it clicks into horizontal position, then lift
out of fryer.
3. Pour cooking oil into Oil Reservoir until it reaches between “MIN” and
“MAX” marks inside reservoir. DO NOT OVER OR UNDER FILL.
4. Replace Frying Basket and close Lid.
5. Press the Handle Release Button to lower the basket into the oil.
6. Make sure that the fryer is OFF and insert plug into 120 volt AC outlet.
7. Turn fryer to desired temperature position. The Power Light will
illuminate. The Ready Light will illuminate when the oil has reached
the preset temperature.
8. Open Lid and lift Frying Basket into upper position by lifting handle
up until it clicks into the horizontal position.
9. Place food inside the Frying Basket (Do not over stack food). Close lid
until it snaps into place. Lower the Frying Basket into the oil by
pressing the Handle Release Button. CAUTION: Always close the Lid
before immersing food in oil. Do not immerse or drain food with the
lid removed or open.
10. Set built in electronic timer.
NOTE: Timer can be set in 1 minute increments for up to 60 minutes
and will beep at completion. Press the button to desired time, after 2
seconds the timer will flash twice then become constant. The Timer
will then begin counting down. When one minute is remaining, the
timer will display seconds. At the end of the desired time, a set of 10
beeps will be heard. After another 20 seconds, a set of 10 more
beeps will be heard. The timer will shut off in energy saving mode.
This will not shut off the Fryer. You must complete Step 6 to do so.
Reset the timer by pressing and holding the button for 2 seconds
during countdown.
11. After time is up, turn temperature to OFF. Pull up the Handle until it
clicks into the horizontal position. To remove excess grease and retain
crispness, let food drain in Frying Basket at least 10-20 seconds. Open
Lid, lift Frying Basket by Handle and pour contents onto plate
covered with paper towels before serving.
12. When finished cooking, make sure fryer is in the OFF position.
WARNING: DO NOT USE SureRELEASE
TM
POWER CORD SYSTEM
TO DISCONNECT THE FRYER. ALWAYS DISCONNECT PLUG
FROM WALL OUTLET FIRST TO DISCONNECT FRYER. Use only
Model #LM-132 magnetic cord set with this product. The use of any
other magnetic cord set may cause fire, electric shock, or injury.
CAUTION: The SureRELEASE
TM
Power Cord is only for accidental
disconnection and is not to be removed during normal operation. If
the cord becomes disconnected, the user should immediately unplug
the cord set from the wall outlet, then reconnect the magnetic cord
to the deep fryer.
13. Correct operation of the basket: Lift handle to lock basket in
raised position. Slide the Handle Release Button backwards to lower
the basket into oil.
WARNING: Always turn control to OFF then disconnect plug from
wall outlet BEFORE disconnecting SureRELEASE
TM
POWER CORD.
CAUTION:
• Do not immerse cord sets in water or any liquids
• Do not attempt to defeat the detachable magnetic SureRELEASE
TM
Cord system by trying to permanently attach cord set to product.
USING YOUR DEEP FRYER USING YOUR DEEP FRYER (CONT.)
CARE AND CLEANING
Figure 2
