745568

Rika Room Temperature Sensor Manual

5
Zoom out
Zoom in
Previous page
1/20
Next page
Compare the positions of the small DIP switches (jumpers) 1-4.
Switches 1-3 are used for defining wireless addresses, and must match in both devices.
Tip
The standard settings can be retained. The DIP switches only need to be modified in special
cases.
DIP switch no. 4 of the wireless room sensor increases the transmitter power.
Q Setting OFF - approx. 1 mW
Q Setting ON - approx. 10 mW
The ON setting is used when the distance from the transmitter to the receiver is too large, or
when an obstacle negatively affects the reception signal.
Note
When set to ON, DIP switch no. 4 on the receiver serves for a test transmission of 25 °C, and for
controlled heating operation it must be returned to the OFF position.
Dismantle the rear wall of your pellet stove (or the side panel, depending on stove type) as
described in the operating manual.
Depending on the stove type, you have to cut out the rectangular recess at the rear of the
stove either in order to feed the cable through, or to install the receiver there. In this case, cut
through the connecting struts of the rectangle using a hacksaw blade, and use a file to remove
the remnants of the struts.
The appropriate drill holes are provided for the correct positioning of your wireless receiver on
the backing plate of the motherboard. Install the mounting plate on the backing plate of the
motherboard using the screws, washers and nuts included in the delivery.
Installation example:
|5
EN
4
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Room Temperature Sensor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Room Temperature Sensor in the language / languages: English as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info