744638
15
Zoom out
Zoom in
Previous page
1/24
Next page
|15
EN
14
Adding wood
Fill amount for heating up: 2 logs of max� total 2�5kg, depending on
requirements�
The red flashing phase varies depending on the ambient influences
between 5 and 10 min� If the combustion chamber door is opened,
the display changes to green flashing�
If the temperature increase is sufficient (wood added and lit), the
display changes to constantly green (the RIKATRONIC3 starts the
burn-off control)�
If an increase in temperature in not detected, the display changes,
depending on combustion chamber temperature, to the status prior
to adding wood, either to red flashing or to constantly red.
Burn out
If no more wood is added during the red flashing phase, the display
changes to constantly red� No more logs may be added from this
point since ignition of any logs added cannot be ensured� The stove
must be heated up again�
ECO operation
If the room to be heated and the stove are already at temperature,
continued operation with lower heat output and log addition is
possible�
Fill amount in ECO operation: 2 logs in total approx� 1�5kg
If the Eco key is pressed when adding wood (after closing the
combustion chamber door), the display changes to yellow flashing
and Eco operation is activated�
This operating mode also regulates the burn off with lower heat
output to the optimum�
If the Eco key is pressed again or the combustion chamber door is
opened, the display changes from yellow back to green and normal
operation is activated again�
Complete closing of the air flaps
The RIKATRONIC3 has a safety device that prevents the air flaps
closing completely during heating operation (hazard of deflagration)�
However the air flaps can be closed completely with a sequence of
ECO key and opening and closing the combustion chamber door to
stop the existing draught on stove standstill�
Q Ensure that the stove has cooled down, is switched off and that
the combustion chamber door is closed
Q Plug in the mains plug and activate the main switch at the rear
of the stove
Q Wait until the reference run has been completed and the display
lamp is constantly red
Q Now depress the ECO key for 5 sec with the combustion chamber
door closed until the display changes to yellow flashing
Q Open and close the combustion chamber door, the display is now
constantly yellow
Q The depress the Eco key again for 5 sec until a click is heard and
the air flaps close completely
As soon as the air flaps reach end position, the display goes off and
the stove can be switched off and the mains plug disconnected�
Power failure
In the event of a power failure the air regulation flap remains
unchanged until the fire goes out (no display)� If mains voltage is
available again after a brief power failure, the display lights up as
on start for 10 sec green and then changes to red flashing due to the
repeat reference run of the air flap motor
If the temperature of the stove is still more than 80°C, the display
changes and the control system changes to the respective status�
If the stove cools back down during the power failure, the display
changes to constantly red
Manual regulation
Note
Manual operation may only be performed with the unit switched off�
Any other procedure than that stated below may cause damage to
components and inevitably leads to loss of warranty�
Q Switch the stove off at the main switch and disconnect the mains
plug�
Q Insert the socket spanner supplied sufficiently far into the sleeve
as shown�
Symbolfoto
Turning clockwise opens the air flaps; anti-clockwise closes them�
Q Turn the socket spanner first to heating-up position (open until a
stop is detected)�
Q Turn the socket spanner gradually anti-clockwise after the
heating-up phase to control the air intake and thus the burn-off
manually�
Symbolfoto
Note
Always ensure that the stove is supplied with sufficient air for
combustion; otherwise increased smoke development may occur
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Look RLU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Look RLU in the language / languages: English as an attachment in your email.

The manual is 6,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Rika Look RLU

Rika Look RLU User Manual - German - 24 pages

Rika Look RLU User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info