793453

Respekta CH3100GISA - Aluna Manual

31
Zoom out
Zoom in
Previous page
1/36
Next page
1 Preparations
English 17. Installation Instructions for Island Cooker Hood
GB
1. Determine the exact location for the hood; ensure availability of the power
cable at the correct location.
2. The ceiling must support a load of at least 40 kg and be at least 40 mm
thick.
3. The ceiling must be aligned perpendicularly to the cooker hood installation
location. Deviations in excess of 1.5 mm must be compensated by suitable
construction measures to prevent the hood from hanging askew from the
ceiling.
4. A ceiling core drilling diameter 170 mm must be available before installing
the hood.
5. An exhaust air pipe for connecting the exhaust air hose A (Fig.1) must be
available or fitted prior to the installation of the hood.
6. The exhaust air hose A (Fig. 1) is not supplied with all appliances.
Whatever the case it must be obtained prior to commencing the hood
installation.
7. Comply with the prescribed distance of the hood to the hob. (Fig. 1)
2 Installing the hood
1. Hold the mounting plate A (Fig. 2) against the wall at the appropriate
location and mark on the ceiling the screw holes and where necessary
the hose section B (Fig. 2).
2. Drill the holes marked on the wall and insert the plugs for fixing the
mounting plate.
For secure fixing of the mounting plate, use all the 6 x 40 mm flat head
screws supplied.
3. Make sure the area is absolutely free from drilling dust and building
waste.
4. Mount the exhaust air hose A (Fig. 1) to the on-site exhaust air pipe.
5. Place the mounting plate A (Fig. 2) with its hose cut-out over the
suspended xhaust air hose (see Fig. 3) and fix to the ceiling with the
screws C (Fig. 2) size 6 X 40 mm.
6. Fix a perforated angle bar A (Fig. 4) to each of the 4 corners of the
mounting plate. (Fig. 3) Use two M4 X 10 mm screws with nuts and
washers.
7. Calculate the required overall length of the angle bars:
Height of the hob from the kitchen floor
+ 65 cm up to max. 75 cm
+ 8 cm resp. height of the hood body
= hood mounting height D (Fig. 1)
Room height
- Hood mounting height
= required overall length of angle bars B (Fig.5)
Read the general Instructions for use/operation carefully before mounting the cooker hoods
Fig. 1
A
B
C
D
Fig. 2
A
Fig. 4
A
Fig. 3
Fig. 5
AB
fi200330TNM
11
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Respekta CH3100GISA - Aluna at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Respekta CH3100GISA - Aluna in the language / languages: English, German as an attachment in your email.

The manual is 1.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info