Manual Renkforce RF1000 (page 83 of 114) (English)

536366

Zoom out

Zoom in

1/114

Filament Settings

(1) Filament diameter and ﬁlament diameter tolerances according to the manufacturer speciﬁcation are set here. If no

manufacturer’s

speciﬁcation is present, these values can also be measured with a calliper (measure 1 m of ﬁlament material

in 10 dierent points and then set the average here).

(2) Temperature settings for extruder and heating bed separated by ﬁrst and all other layers.

Observe the settings recommended by the ﬁlament manufacturer!

Since the best values may ﬂuctuate extremely depending on the ﬁlament manufacturer, perform your own tests based on

the pre-settings to achieve the best printing quality. When performing the tests, proceed in 5 °C steps and compare the

results during or after printing with other settings. The ﬁrst layer should always be printed a little more hotly for better

adhesion on the heating plate.

(1) Here you can choose between automatic cooling and permanent operation of the fan at the extruder.

(2) Setting

of the fan speed.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce RF1000 in the language / languages: English as an attachment in your email.

The manual is 8,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Renkforce RF1000

Renkforce RF1000 User Manual - German - 104 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Renkforce RF1000 Manual

Product: