569769
46
Zoom out
Zoom in
Previous page
1/51
Next page
Rendama
x
Doc890/3456CV02B 49
Check that there is a by-pass or a low velocity header fi tted in the hydraulic system. This is a
requirement.
Check and bleed the pump
Switch on the power supply to the boiler at the on/off switch and check the direction of rotation of
the boiler pump after removing the end cap from the pump motor housing. If the direction of rota-
tion is incorrect, two of the three phase connections must be swapped.
Before the appliance is started up, any air present must be bled out of the pump by removing the
end cap from the pump motor housing. This must be repeated after the appliance has been in
operation for a short time.
Check the chimney
Check the chimney. Ensure that the connection between the appliance and the chimney is such
that gassses cannot es cape. If necessary, apply an appropriate sealing tape.
Bleed the gas pipwork
Open the gas valve. Check that the gas piping is gas-tight. Remove any air between the gas valve
and the appliance.
Check the operation of the appliance at full capacity
Start up the appliance. Allow the appliance to operate at full capacity and to stabilise (approxi-
mately 3 minutes). At full capacity, the following settings must be checked and corrected if neces-
sary.
Pilot burner CO
2
[%] 9.8 - 10.2
Pilot burner CO [ppm] ≤ 1000
Main burner CO
2
[%] 9.8 - 10.2
Main burner CO [ppm] ≤ 30
Burner pressure p
fan
– p
above burner
[mbar] 9.0 ± 1
Propane
Pilot burner CO
2
[%] 10.8 - 11.2
Pilot burner CO [ppm] ≤ 1000
Main burner CO
2
[%] 10.8 - 11.2
Main burner CO [ppm] ≤ 30
Burner pressure p
fan
– p
above burner
[mbar] 9.0 ± 1
Table 15 Settings at full capacity
Fig. 33 Burner pressure measurement
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rendamax R3500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rendamax R3500 in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info