587853
24
Zoom out
Zoom in
Previous page
1/32
Next page
16-20 mm
min. 2% fall
Riser pipe too far away Condensation pipe too large/small
No fall
Cannot freely drain
away
Condensation connection - Wrong! Condensation connection - Correct!
maximum
1000 mm
max. 100 mm
Electrical connection
All electrical installation
work should be performed
by specialist contractors.
Isolate the voltage supply
when connecting the electrical
terminals.
CAUTION
We recommend that customers
install a main/repair switch
in the vicinity of the outdoor
component.
The terminal blocks for making
the connections are located at
the rear of the unit. When the
unit is installed, measurements
can be made from the front by
removing the cover.
If an optional condensation
pump is used in conjunction
with the unit, it may be
necessary to install an
additional relay with a higher
contact rating after the switch-
off contact on the pump to
A protected mains supply
cable and control cable should
be connected to the outdoor
component and indoor unit
respectively.
Connecting the indoor unit
Make the connection as follows:
1. Open the air intake guard.
2. Unfasten the cover on the right
side and at the bottom right
rear (Fig 12).
3. Connect the unit to the
control cable from the outdoor
component.
See electrical connection
diagram
4. Re-assemble the unit.
switch off the compressor.
Control cables should be
screened if laid in areas exposed
to strong magnetic fields.
Details concerning the electrical
protection of the system are
given in the section on technical
data.
Check all plugged and clamped
terminals to verify they are
seated correctly and making a
permanent contact. Re-tighten
as required.
CAUTION
Terminal block
for control
cable
Cover
Control cable
from outdoor
component
Strain relief
12
Connecting the indoor unit
REMKO SV
24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO SV681 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO SV681 in the language / languages: English as an attachment in your email.

The manual is 3,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO SV681

REMKO SV681 User Manual - German - 32 pages

REMKO SV681 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info