794459
15
Zoom out
Zoom in
Previous page
1/28
Next page
15
2. Open the air flap on the top
of the unit.
3. Use the Power button.
4. Use the SET key to select
thedesired humidity level in the
installation room
Commissioning
Control panel
NOTE
In room temperatures below
10 °C
and relative humidity
below
40 %
, economical use
of the unit can no longer be
guaranteed.
NOTE
Note that the compressor does
not switch on until a waiting
time of 3 minutes has elapsed.
Restart protection!
NOTE
The devices can be switched
ON and OFF via an external
time (accessory) if required.
Before commissioning the unit
or if local requirements dictate,
the air-inlet grill and air-outlet
grill must be checked for
contamination.
Important notes prior
to commissioning
All extensions to the electrical
connection must be of
a sufficient cable size and must
only be used fully rolled out or
unrolled
Never use the mains cable
as a pull cord
After being switched on,
the units operate fully-
automatically until switched off
by the hygrostat or float when
the condensate container is full
The condensate container must
be inserted properly
The unit cannot be operated if
the condensate container is not
inserted properly!
In order to prevent damage to
the condenser, the units are
equipped with a mechanism
that prevents the compressor
being immediately switched
back on after it is switched off
The units do not switch back
on until a waiting time of
around 3 minutes has elapsed!
If the units work in continuous
operation with an external
condensate drainage
connection, refer to the
relevant section
NOTE
A contaminated grille or filter
must be cleaned or replaced
immediately.
The units are only permitted
to be operated with the air
flap open in order to prevent
overheating.
! CAUTION
Commissioning the units
1. Connect the unit's electrical
connection to a properly
installed mains socket.
MAX. AUTO
rF
SET
21
4
356
Power key
The POWER key switches the unit on and off.
SET key
Use the SET key to select the desired humidity in the installation
room.
„MAX“ status light
This light indicates that the unit is in continuous operation
„AUTO“ status lights
These lights indicate which humidity level has been set. .
“Container full” indicator light
This light indicates that the condensate container is full and must
be emptied
Defrost mode” indicator light
This light indicates that the automatic defrost system that
is integrated in the unit has switched on the defrost cycle
1
2
3
4
5
6
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO SERIE ETF 320 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO SERIE ETF 320 ECO in the language / languages: English as an attachment in your email.

The manual is 2.94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO SERIE ETF 320 ECO

REMKO SERIE ETF 320 ECO User Manual - German - 28 pages

REMKO SERIE ETF 320 ECO User Manual - Dutch - 28 pages

REMKO SERIE ETF 320 ECO User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info