587737
20
Zoom out
Zoom in
Previous page
1/28
Next page
20
G
Prior to performing any work on the unit, it must be
unplugged from the power supply and secured
against being inadvertently switched on!
Electrical Connection
For all units, the power supply must be installed on the
indoor units. The system’s fuse protection must be in
line with the technical requirements and the local condi-
tions.
Local guidelines for operation as well as the require-
ments established by local energy supply companies
must be observed for setup and initial operation.
Connecting the indoor unit
Proceed as follows to connect the lines:
1. Open the cover of the connection area of the indoor
unit.
2. Connect the power connection line of the indoor unit
to the power supply.
3. Close the customer-installed connection lines as de-
scribed below on the connection terminals of the in-
door unit.
4. Place the customer-installed connection lines to the
outdoor part.
Instructions for electrical connection
Inside the indoor units for all air-conditioning units, there
are connection terminals for the power connection and
the customer-supplied connection line.
The power connection line is already permanently wired
in the indoor unit up all air-conditioners. If the existing
power connection line is not long enough, replace it
keeping in mind the required cross-sections and termi-
nal connections.
For the RKS 350 H units, the sensor line supplied with
the unit must also be laid. If the distance to be covered
with this line is more than 10 m, the line must be length-
ened by the customer!
Electrical wiring diagram RKS 327 / 335 H AT
Condenser fan
1 2(N) 3 4
Compressor
Winter regulation mechanism
Sensor
fluid line
Condenser Condenser
Reverse
valve
M M
1 2(N) 3 4
Winter regulation mechanism
Condenser fan Compressor
Sensor
fluid line
Condenser Condenser
Reverse
valve
M M
Plug
Sensor
frost protection
Electrical wiring diagram RKS 350 H AT
Electrical wiring diagram RKS 371 H AT
Condenser fan
Compressor
Winter regulation
mechanism
Condenser
Reverse valve
Contactor
Condenser
Sensor fluid line
Sensor frost protection
Before proceeding with the connections, please read
the following instructions:
àElectrical installations may only be performed by
authorised service personnel in accordance with the
relevant regulations.
àAn all-channel main switch must be installed by the
customer in the supply line close to the indoor unit;
we recommend using a main or repair switch.
àPower for the outdoor part is supplied via the con-
nection line from the indoor unit.
àThe power supply’s cross-section is based on the
design specifications and the connection capacity of
the unit.
àThe connection lines to be installed by the customer
can be combined as follows:
RKS 327 H to RKS 350 H
A 3-wire and a 2-wire connection line or a 5-wire
connection line.
RKS 371 H
A 3-wire and a 6-wire connection line.
àIn some cases, we recommend separating the con-
trol line and the power supply line (L / N / PE) of the
outdoor part into two different lines with different
cross-sections for the units RKS 335 H to RKS 371 H.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RKS335H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RKS335H in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RKS335H

REMKO RKS335H User Manual - German - 28 pages

REMKO RKS335H User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info