587723
21
Zoom out
Zoom in
Previous page
1/28
Next page
Electrical connection
A protected mains supply cable is
to be connected to the outdoor
unit and 4-core control line is to
be connected to the indoor unit
respectively.
All electrical installation
work should be performed
by specialist contractors.
Isolate the voltage supply
when connecting the electrical
terminals.
CAUTION
Make the connection as follows:
1. Open the air intake grill.
2. Unfasten the covers on the right
side (figure 6).
3. Loosen the control line on the
terminal block and remove the
control cable.
4. Connect the control line that
has been pre-prepared on-site
to the terminal (see electrical
connection diagram S.20).
5. Connect the on-site pre-
prepared control line with
the supplied control cable in
a professional manner.
6. Insert the control line plug into
the corresponding socket on the
outdoor unit.
7. Re-assemble the unit.
Terminal block
Control line
Cover
Strain relief
Control line from
the outdoor unit
Cover
6
Connecting the unit
The device's scope of delivery
includes a five metre long, four-
core control line for connecting the
indoor unit to the outdoor unit.
The control line to the outdoor
unit contains a data cable which
serves to realise communication
between the indoor unit and the
outdoor unit. This is used for
controlling the cooling and heating
performance and for forwarding
fault indications to the indoor unit.
If the length is insufficient, you can
extend these control lines on the
indoor unit.
We recommend to install
a main / repair switch on the
building near the indoor unit.
The terminal blocks for making
the connections are located at
the rear of the unit. When the
unit is installed, measurements
can be made from the front by
removing the cover.
If an optional condensation
pump is used in conjunction
with the unit, it may be
necessary to install an
additional relay with a higher
contact rating after the switch-
off contact on the pump to
switch off the compressor.
21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MXW520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MXW520 in the language / languages: English as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MXW520

REMKO MXW520 User Manual - German - 28 pages

REMKO MXW520 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info