587703
21
Zoom out
Zoom in
Previous page
1/32
Next page
Connecting the outdoor
component
Proceed as follows to connect the
cable:
1. Remove the plastic panel at the
connector.
2. Select the cable cross-section
according to the relevant
standards.
3. Feed both cables through the
edge protection rings on the
fixed connection panel.
4. Connect the cables as shown
on the electrical connection
diagram.
Electrical connection diagram
Connection ML 262 DC to ML 522 DC
Check all plugged and clamped
terminals to verify they are
seated correctly and make
a permanent contact. Tighten
as required.
ATTENTION
5. Anchor the cable in the strain
relief and re-assemble the unit.
(figure 12).
12
Connecting the outdoor component
Connecting the indoor
unit
Make the connection as follows:
1. Open the air intake grill.
2. Loosen the cover to the
terminal strip on the right side.
(figure 11).
3. Connect the unit to the
control cable from the outdoor
component. See electrical
connection diagram.
4. Re-assemble the unit.
11
Connecting the indoor unit
Outdoor
component
Indoor unit Mains cable
Neutral conductor
Exterior conductor
Earth conductor
230 V~,
50 Hz,
L1 / N / PE
Data cable
L1
S
S
N
N
L1
Indoor unit
21
Control cable and
voltage supply to
the outdoor unit
Cover
Terminal strip
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ML522 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ML522 DC in the language / languages: English as an attachment in your email.

The manual is 1,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ML522 DC

REMKO ML522 DC User Manual - German - 32 pages

REMKO ML522 DC User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info