587595
5
Zoom out
Zoom in
Previous page
1/24
Next page
5
Operation
Two to four seconds after the indoor unit has been con-
nected to the power supply, operation can begin.
Inserting the batteries into the remote control
Prior to initial operation, the batteries supplied with the
unit (2 type AAA batteries) must be inserted into the re-
mote control.
1. Slide off the cover of the battery slot on the back of
the remote control and insert the batteries.
2. Make sure that the polarity is correct.
Use the labelling in the slot.
3. Close the battery slot again.
The remote control
The air conditioner is operated using the infrared re-
mote control.
A beep the signal has been correctly received after a
button is pressed.
4
1
2
8
6
5
7
9
11
3
12
10
13
14
3 button
This button is used to increase the temperature up
to a maximum of 31°C.
4 Mode button
The operating mode is selected with this button. The
indoor unit has 4 modes:
Automatic:
In this mode, the unit operates in cooling or heat-
ing mode.
Operating cycle of the compressor:
On 20 min. Off 10 min.
Cooling:
In this mode, the warm room air is cooled down to
the desired temperature.
Dehumidifying:
In this mode, the room is primarily dehumidified
and the set temperature is maintained.
Heating:
This mode is not available.
If this mode is activated, the compressor begins to
operate and causes the unit to malfunction!
5 Fan button
The desired fan speed is set with this button.
The following 4 speeds are available:
Automatic, low, medium and high fan speed.
6 Fin button
The position of the air outlet fins is set with this but-
ton.
There are 5 positions and an oscillating function
available.
7 Sleep button
After this button is pressed in cooling mode, the tar-
get temperature automatically increases by 1°C
within one hour.
8 SWING button
This button immediately activates the oscillating
function of the fins to improve the air distribution in
the room.
9 Timer On button
The unit is programmed to automatically switch on
within the next 24 hour-period with this button.
10 Timer Off button
The unit is programmed to automatically switch off
within the next 24 hour-period with this button.
11 HR button
The hours are set with this button.
12 MIN button
The minutes are set with this button.
13 Reset button (in the battery slot)
The settings are reset by pressing this button.
14 Clock button (in the battery slot)
The time setting is activated by pressing this button.
1 ON/OFF button
The unit is switched on with this button.
The settings appear on the display.
2 button
This button is used to decrease the temperature
down to no lower than 16°C.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ML520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ML520 in the language / languages: English as an attachment in your email.

The manual is 1,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ML520

REMKO ML520 User Manual - German - 28 pages

REMKO ML520 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info