587577
21
Zoom out
Zoom in
Previous page
1/32
Next page
Connection variations of
inner unit
Unit installation
When attaching the interior unit,
pay attention to the lower, upper
and side area air discharge.
1. Mark the mounting points on
the statically admissible building
sections, according to the
dimensions of the unit.
2. Open the display cover (Fig.
8) and remove the two screws
underneath the filter (Fig. 9).
3. Remove the front of the unit
by lifting the front in the lower
area from the body approx. 10
cm and folding it upward
(Fig. 10).
4. Pull the plugs of the front cover
from the circuit board (Fig. 11).
5. If necessary, remove the break
out opening of the housing.
6. Install the unit on the wall.
7. Connect the refrigerant,
electrical and condensation line
to the interior unit, as described
below.
8. Recheck the horizontal
alignment of the unit.
9. Reassemble the unit.
Installation of the interior unit
The wall bracket for the unit must
be attached with suitable screws
and anchors.
Installation
The installation may only
be made by authorized
technicians.
NOTE
Oil return measures
If the exterior unit is located at a
higher level than the interior unit,
then suitable oil return measures
must be made. This is usually done
by fabricating an oil lift fitting,
which is to be installed for each
2.5 ascending meter.
Oil return measures
Exterior unit
Oil lift fitting in the
suction line to the
exterior unit
1 x for each 2.5
ascending meter
Radius:
50 mm
max. 5 m
exterior unit
8
Open display cover
4
Connection variations
1 Outlet on the wall, right
2 Outlet through the wall, right
3 Outlet through the wall, left
4 Outlet on the wall, left
View from the rear
1
2
9
Remove screws
10
Release the unit
front
11
Pull off the plug
3
21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ATY350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ATY350 in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ATY350

REMKO ATY350 Additional guide - German - 1 pages

REMKO ATY350 User Manual - German - 32 pages

REMKO ATY350 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info