616904
6
Zoom out
Zoom in
Previous page
1/136
Next page
6
, STEP 5 – The nishing touches
• Usetheclipperwithoutanattachmentcombforclosetrimmingaroundthe
base and sides of the neck.
• Toproduceacleanstraightlineatthesideburns,reversethehairclipper.Place
the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
, SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Startingwiththelongestxedcomb(25mm),cutfromthebackoftheneckto
the crown. Hold the guide comb at against the head and slowly move the
clipper through the hair.
• Usethesameprocedurefromthelowersidetotheuppersideofthehead.
Then cut the hair against the direction in which it grows and level with the
sides.
• Togivea“attop”look,thehairontopoftheheadmustbecutoverthetop
of a at comb.
• Useacloserguidecombtotaperthehairdowntothenecklineasdesired.
C CARE FOR YOUR HAIRCLIPPER
, AFTER EACH USE
• Ensuretheapplianceisswitchedoandunpluggedfromthemainsbefore
cleaning.
• Brushtheaccumulatedhairfromtheblades.Thebladesandproductunitcan
be rinsed under the tap. Please see cleaning section below on this.
• Itisrecommendedthatthebladesshouldberemoved,andanyaccumulated
hair be brushed out after each use. 1 or 2 drops of clipper oil should be added
to tip of blades, and a drop on the back gliding surfaces.
, REMOVING AND REATTAHCING THE BLADE SET
• Thebladescanbereleasedbyplacingyourngerorthumbintothepush
release point and sliding the blade o the product unit.
• Toreattachplacethebladesetontopoftheproductunitandslidethisgently
into place until you hear and feel it click into place.
, CLEANING CAUTIONS
• Thisclipperisfullywashable.Theclipperandbladesetcanberinsedunder
the tap for cleaning. Only rinse the blades when needed.
• Foradeepclean,letthebladesrunwhilerinsingunderthetap.
• Pleaseensuretheproductisfullydriedafter,especiallythebladesetsurfaces.
• Caution:donotwashwhenpluggedintothemainspower.
ENGLISH
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remington HC5880 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remington HC5880 in the language / languages: All languages as an attachment in your email.

The manual is 2,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info