805754

Remeha E-HP AW 44 Cool Plus B Manual

27
Zoom out
Zoom in
Previous page
1/44
Next page
Make sure that there is enough free space between the heat pump and
walls or fences, to secure that the air flows freely and to allow access for
maintenance work.
The appliance can function up to (and above) 1000 m above sea level.
Make sure the appliance is accessible for safe operation and
maintenance purposes.
The control box of the heat pump must not be:
More than 1.9 m above service level.
More than 0.6 m below service level.
It is advised to install the appliance with the air inlet towards the
downwind position. This allows for correct defrosting of the evaporator.
If the appliance is positioned free-standing, wind influence can cause
differences in operation characteristics. Therefore we advice to place
the unit in line with the airflow over the appliance.
Consider the noise emission while selecting the location for the
appliance.
Consider that a condensate drainage may have to be installed.
A 1.5 m (3 m for the E-HP AW 168)
See also
Connecting the condensate drain, page 31
5.2 Preparing the location
Caution
Use UV and bird pecking resistant materials for insulation that is in
the open air.
The installation site must be equipped with the following electrical
connections and heating pipes:
Item Amount Specification
Connection cable for
the compressor(s)
1 (2 for 168 kW) 3 / N / PE ~ 50 Hz /
400 V
Connection cable for
the controller
1 1 / N / PE ~ 50 Hz /
230 V
Important
The necessary cross section of the cable depends on the power
consumption of the device and the length of the cable.
Item 44 88 168
Heating supply
(external thread)
1 1/2" 2" 2 1/2"
Heating return
(external thread)
1 1/2" 2" 2 1/2"
1. Create a trench or install a cable tray to lead the necessary cables
and pipes from the building to the device.
If a trench of at least 80 cm deep is made, no insulation of the cables
is needed.
2. Lead the cables and the pipes through a protective tube.
Use flexible tubing to prevent transmission of machine sounds.
Fig.16 Installation area
AD-3001684-01
A
2000
A
2000
5 Before installation
7697291 - v.05 - 11032022 27
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remeha E-HP AW 44 Cool Plus B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remeha E-HP AW 44 Cool Plus B in the language / languages: English as an attachment in your email.

The manual is 12.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info