413692
14
Zoom out
Zoom in
Previous page
1/25
Next page
REL Acoustics ‘Q’ range User manual
14
To connect to the amplifier/processor using the phono to phono low level
interconnect
Two low level inputs are provided, 0dB and +12dB, One only on Quake and Q108 at +12dB
Connect as shown above. Although a twin phono to phono interconnect is supplied, only one core
need be used, either the red or the black. Plug one end into the sub/LFE output on the
amplifier/processor and the other end into the 0dB input (single input on Quake and Q108) on the sub
woofer.
On the models with two low level phono inputs, if the output is too low when using the 0dB input then
use the more sensitive +12 dB input.
The output level is adjusted using the control marked LO LEVEL
If the low level connection is to be made to left and right pre-amp outputs then a 12dB attenuator is
available to balance the 0dB and +12dB phono inputs. See below.
One Q108 not suitable for this type of connection. Two Q108 units would be required.
Supplied Phono to Phono Interconnect. To sub/LFE output of
Amplifier/Processor
Sub Low Level
Input. (One phono
Only on Quake and Q108)
.
Sub Low Level 12dB Supplied phono to phono
Input Attenuator interconnect
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rel quake at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rel quake in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info