6
2
30
11
8
7
Hole
10
10
7
5
6
2
31
4
54
56
4. Connect the Resistance Control (31) to the
Extension Cable (56) in the following way:
• Refer to drawing A. Insert the tip of the short cable
on the Resistance Control (31) into the wire clip on
the Extension Cable (56) as shown.
• Refer to drawing B. Firmly pull the short cable and
slide it into the metal bracket as shown.
Push any excess Extension Cable (56) into the
Upright (2).
Attach the Resistance Control (31) to the Upright (2)
with an M5 x 13mm Phillips Screw (54).
2. Insert the Seat Post (6) into the Frame (11). Press
the Seat Post Bushing (30) into the top of the
Frame.
Next, align one of the holes in the Seat Post (6) with
the hole in the Frame (11). Thread the Seat Knob
(8) into the Frame and the Seat Post, and tighten
the Seat Knob into the Frame. Make sure to insert
the Seat Knob through one of the holes in the
Seat Post; do not insert the Seat Knob under the
Seat Post.
Attach the Seat (5) to the Seat Post (6) with four
M6 x 16mm Bolts (7) and four M8 Washers (10).
Note: The bolts and washers may be pre-attached
to the bottom of the Seat.
3
3. While a second person holds the Upright (2), con-
nect the Extension Wire (42) to the Reed Switch
Wire (25). Next, carefully slide the Extension Cable
(56) up and out through the indicated slot in the
Upright.
Carefully slide the Upright (2) onto the Frame (11)
and attach it with four M8 x 15mm Button Head
Bolts (57) and four M8 Washers (10). Be careful to
avoid pinching the wires inside the Upright and
Frame.
2
57
25
10
56
11
57
10
42
Slot
56
56
31
31
B
A
