597827
175
Zoom out
Zoom in
Previous page
1/250
Next page
RED SCARLET-X OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC
955-0003_v4.0, Rev-A | 175
HD-SDI
A standard 75 Ohm BNC connector provides a broadcast specification high definition video output.
PIN
SIGNAL
DESCRIPTION
DIRECTION
Center
HD-SDI
SMPTE-292M HD-SDI
Out
Shield/Screen
GROUND
Camera ground
--
The HD-SDI output provides a 720p progressive scan video feed operating at 50.00 or 59.94 Hz or a 1080p
10-bit 4:2:2 progressive scan video feed operating at 23.98, 24.00, 25.00 or 29.97 Hz when in 1.5GHz HD-
SDI mode, or a 1080p 10-bit 4:2:2 progressive scan video feed operating at a 50.00 or 59.94 Hz when in
3GHz HD-SDI mode.
The HD-SDI output may be specified as a PROGRAM output (clean feed video) or as a PREVIEW output
(includes SurroundView™ look around, Clip Name, Timecode and Safe Action / Safe Title frame guides).
In addition to video, the HD-SDI output also provides two channels of embedded audio, Time of Day and
Edge timecode, record Tally flag and Clip Name information as SMPTE RP-188 VITC2 HANC metadata.
NOTE: Default setting is PROGRAM.
NOTE: HD-SDI video output is Progressive Scan; it does not support 1080i or 1080PsF modes.
HEADPHONE
A 3.5mm stereo jack provides two channels of adjustable level analog audio for monitor headphones.
Headphone Output Connector
PIN
SIGNAL
DESCRIPTION
DIRECTION
A (TIP)
LEFT
Left channel audio
Out
B (RING)
RIGHT
Right channel audio
Out
C (SLEEVE)
GND
Camera ground
--
The camera’s four audio channels may be monitored in pairs: either 1L - 2R or 3L - 4 R or as a quad mix of
1+3L 2+4R based on the MIX parameter. Default is 1L-2R.
Output volume may be adjusted as follows.
Volume
: (master volume) Adjusts headphone volume equally for left and right outputs.
Range is -18dB to 0dB in 1dB steps. Default is -9dB.
NOTE: For maximum output signal quality, only use high impedance headphones.
NOTE: in Version 4.x firmware the above selection is not available, the output is set to 1L / 2R.
A
B
C
175


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Red Scarlet X 4.0 - 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Red Scarlet X 4.0 - 2013 in the language / languages: English as an attachment in your email.

The manual is 18,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info