597818
61
Zoom out
Zoom in
Previous page
1/64
Next page
Feb 07 2008 Copyright RED Digital Cinema
61
Pin
Signal
Description
1
-VOUT
Auxiliary power return (Ground)
2
GPI
Trigger
3
GPO
Tally
4
+VOUT
Auxiliary power output,
Note: Commencing with Build 10 firmware, Pins 2 and 3 can be used to provide an external
Trigger and Tally signal. The function of each GPIO pin can be configured by the operator,
however the default setting for the upper connector is Pin 2 = Record Start/Stop and Pin 3 =
Record Tally. For the lower connector, the default setting is Pin 2 = Record Next Frame and
Pin 3 = Frame Record Completed. Use this for animation or simple motion control interface.
Timecode Input
This connector supports SMPTE Timecode input and output. Pins 2 and 3 may be used together
to receive a balance SMPTE 12M serial time code input, or pin 2 may be used by itself (leave
pin 3 open) to receive a single-ended SMPTE 12M serial time code input.
Mating connector: LEMO FGG.0B.305.CLAD42Z (straight)
1
2
3
4
5
View into camera Timecode connector
Pin:
Signal
Description
Direction
1
Ground
Camera ground
-
2
TIMECODE_IN_P
Serial timecode input, positive
in
3
TIMECODE_IN_N
Serial timecode input, negative
in
4
-
-
-
5
-
-
-
Note: Pin 5 is reserved for future use for single-ended SMPTE 12M serial time code signal out.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Red One 14.0 - 2008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Red One 14.0 - 2008 in the language / languages: English as an attachment in your email.

The manual is 6,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info