23315
25
Zoom out
Zoom in
Previous page
1/45
Next page
16 ST40 Wind Instrument Owners Handbook
Connections to the instrument
You can connect your instrument:
Directly to the Rotavecta, transducer as a stand-alone master
instrument. When connected in this manner, the instrument must be
connected to a suitable power source using the 1 m (3 ft) power
cable provided.
As part of a SeaTalk system either as a repeater or, with a wind
transducer also connected as a system master. To connect to
SeaTalk, you will need an additional SeaTalk Interconnection Kit
(Part No. E25028). When connected in this manner, power can be
provided from the SeaTalk bus (e.g. from the autopilot).
You can also connect the instrument to both the Rotavecta transducer
and SeaTalk. When thus connected, the instrument will be the master
wind instrument for the SeaTalk system.
If it is necessary to fit spade connectors to the transducer cable, do so as
shown in the following illustration. Prepare the cable, as at (a), and fit
the spade connectors, as at (b). When fitting each spade connector,
ensure that wire strands do not extend beyond the rear of the spade
connector insulation.
D4467-3
3 mm
4 mm
10 mm
50 mm
Preparing wires for connection
(a)
(b)
160_3c03 .p65 01/05/01, 16:1516
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine ST40_WIND at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine ST40_WIND in the language / languages: English as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info