23315
24
Zoom out
Zoom in
Previous page
1/45
Next page
Chapter 3: Installation
15
Clamp screws
Gasket
Adaptor
pieces
Grub screw
Rail diameter 23 mm (0.9 inch) or more but
less than 25 mm (1.0 inch), use adaptor pieces
Rail diameter 25 mm (1.0 inch),
do not use adaptor pieces
Clamping methods for
different rail sizes
D4834-1
Rail clamp details
Using the Rotavecta rail clamp
Running transducer cable
The Rotavecta transducer has a 20 m (65 ft) cable, fitted with spade
terminals at the free end, for connection to the ST40 Wind instrument.
Observing the following guidelines, run the cable to the instrument:
If the cable has to be fed through the deck, always use a good quality
deck gland.
Where cables are fed through holes, always use grommets to prevent
chafing.
Secure long cable runs so they do not present a hazard.
Wherever possible, route the cable away from fluorescent lights,
engines, radio transmitting equipment, as these may cause
interference.
160_3c03 .p65 01/05/01, 16:1515
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine ST40_WIND at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine ST40_WIND in the language / languages: English as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info