657000
24
Zoom out
Zoom in
Previous page
1/128
Next page
14 RC435 and RC435i Chartplotters
Bracket Mounting
The display unit can be conveniently mounted on a dash area, chart table,
bulkhead or deckhead. Mount the unit as follows:
1. Loosen the mounting bracket knobs and remove the bracket from the
display unit.
2. Mark the locations of the bracket screw holes on the mounting sur-
face.
3. Drill the holes where marked.
4. Use the screws supplied to fix the bracket at the marked locations.
5. Fit the unit to the bracket, adjust the display angle and tighten the
knobs.
Panel Mounting
CAUTION:
Make sure that there are no hidden electrical wires or other items
behind the location before proceeding. Make sure that there is
sufficient rear access for mounting and cabling. Allow at least 6cm at
the right hand side of the display to enable chart cards to be inserted
and removed.
The RC435 can be panel mounted, using the panel-mounting kit
(accessory) available from your local Raymarine dealer. A mounting
template appears at the end of this handbook.
Note: The RC435i with Internal GPS antenna cannot be panel (flush)
mounted.
Panel mount the unit as follows:
1. Check the selected location for the unit. A clear, flat area at least
185mm (7¼ in) wide by 185mm (7¼ in) high, with at least 120mm
(4¾ in) of clearance behind the panel, is required.
2. Using the supplied template, trace the unit cut-out and mark the drill-
ing centers for the four securing holes outside of the cut-out area.
3. To provide start holes for removing the cut-out, drill four 10mm
(
3
/
8
in) holes in each opposing corner.
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. With the mounting bracket and knobs removed, make sure that the
unit fits in the cut-out area.
6. Drill out the four 5mm (
3
/
16
in) securing holes as indicated on the tem-
plate. It is recommended that a 1mm
(
1
/
16
in) pilot hole is drilled first.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine RC435i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine RC435i in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info