657000

Raymarine RC435i Manual

22
Zoom out
Zoom in
Previous page
1/128
Next page
12 RC435 and RC435i Chartplotters
2.4 Installing the Chartplotter
When planning the installation of your RC435/435i, the following points
should be considered to ensure reliable and trouble free operation:
• Convenience: The unit should be installed in a convenient position
where it can be viewed straight on or with a viewing angle of less than
35°. You may wish to apply power before you install the unit, to deter-
mine the best viewing angle prior to fixing. The mounting location
should be easily accessible to allow operation of the front panel con-
trols.
• Access: There must be sufficient space behind the unit to allow cable
connections to the rear panel connectors, avoiding tight bends in the
cable. At least 50mm (2in) should be allowed at the right of the chart-
plotter to enable chart cards to be inserted and removed.
• Interference: The selected location should be far enough away from
devices that may cause interference, such as motors and generators.
• Power Source: The unit should be located near a DC power source.
The power cable supplied is 1.5m (5ft), but a longer cable can be used
if required. Power must be supplied via a 1A quick blow fuse or cir-
cuit breaker. Refer to Running the Cable on page 16.
• Interconnections: The unit transmits navigation and waypoint data
on NMEA and, therefore, can be connected to an NMEA compatible
autopilot or compatible instrument repeater(s). The navigation data
transmitted by the chartplotter is detailed in Appendix A.
• Environment: The unit should be protected from physical damage,
heat sources and excessive vibration. Although the unit is waterproof,
it is good practice to mount it in a protected area away from prolonged
and direct exposure to rain and/or salt spray.
When surface mounting the unit to an enclosed compartment, make
sure that the compartment is ventilated and drained. Failure to meet
this requirement may lead to excessive build up of moisture within
the unit, leading to condensation on the screen.
The dimensions of the unit, including the bracket, are shown in Figure 2-
2 .
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine RC435i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine RC435i in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info