467351
35
Zoom out
Zoom in
Previous page
1/46
Next page
make 25KHz-reference frequency.
Transmit frequency is generated on the Inductor and Capacitor circuit with connected to
IC2 pin 4,5.
The frequency control voltage, which is output from IC2 pin 7, will be input into Variable
Capacitance Diode(D6) on Inductor and Capacitor circuit.
The receiver local frequency is generated on the Inductor and Capacitance circuit with
connected to IC2 pin 20, 21.
The frequency control voltage, which is output from IC2 pin 18, will be input into Variable
Capacitance Diode(D5) composed on
The oscillating frequency 21.25MHz which is output from IC2 pin 11 will be used for the
second local frequency of Receiver and it will be input into IF IC(IC2) pin 1.
10.4 Transmitting Circuit Operation
3.4.1 Microphone Amplifier Circuit:
Voice signal from the mocrophone goes through pre-emphasis circuit consisting of
C147 ,R104 and is amplified in MIC AMP IC8(A).
Pre-emphasis can be output by Diode(D10). The level of the signal is limited by D7
and adjusted in the VR4.
Limiter output is amplified by IC8(B),then it goes through the active 4-stage LPF
consisting of IC8(C) and IC8(D). 4-stage LPF output goes into Variable Capacitance
Diode(D7) and then it makes Frequency modulation.
3.4.2 Transmit Frequency Power Amplifier Circuit
RF signal from the PLL IC(IC2) pin 1 goes through the 10dB attenuator consisting of
R37,R38,R39 and will be amplified by Q11. Output from Q11 will amplify drive power
necessary for the Q4 and Q3. power module(IC5) will be amplified and the RF signal
will be output to the antenna switching circuit. 4-stage LPF consisting of L21 and
L1-L3 is used to improve the level of Transmission Spurious Emission. RF output
from the power module(IC5) can be changed by changing the voltage of IC5 pin2.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine Ray 53 VHF Radio with DSC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine Ray 53 VHF Radio with DSC in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info