Where access is available to the rear of the mounting surface
This method allows for maximum security of a permanently mounted
display. Position the supplied template carefully before starting.
1. Drill three 5mm holes marked "B" on the template.
2 Stick the 3 supplied gaskets on the back of the display.
3. Screw the four M4 brass studs into the rear of the display.
4. Place the display in position pushing the three studs through the
newly drilled holes.
5. Using the three supplied thumb nuts, secure the display to the
surface making sure it is level before final tightening.
5.5 External Power Connections
To connect an external 9 to 30V DC power supply to the display head
from either a portable battery or the vessel’s existing power system.
1. Drill two 7mm holes marked "P" on the mounting template and
smooth them together with a sharp knife or small file.
2. Pass the supply cable through the new hole and attach the supplied
crimp spade receptacles.
3. Remove the blanking plug from the rear of the display to expose the
terminals.
4 Stick the supplied gasket on the back of the display.
5. Taking care to connect the correct polarity push the receptacles
firmly onto the spades on the rear of the case.
6. Mount the display head securely in position following the steps
shown above.
7. Clamp the cable securely close to the display.
mn100 Digital Display
36
www.raymarine.com
