632982
22
Zoom out
Zoom in
Previous page
1/32
Next page
22 Rascal Vision Scooter Owner's Manual and Service Record
Scooter Diagnostic Functions
Your Scooter Controller provides diagnostic information in the form of number and/or symbol codes. The
spanner symbol will appear on the LCD display if a fault is detected and a number in the range 1 to 10 will be
displayed. Upon switching on, the controller conducts a diagnostic test. While this test is in progress the spanner
symbol will flash. This is quite normal. Provided that no fault is detected, the spanner symbol will extinguish. If
t
here is a fault, the spanner symbol will remain on and it will be accompanied by a number. - This fault number
can be referenced against the list below.
Number and/or symbol/s
displayed on LCD Indicated fault and Corrective Action
• Battery needs recharging or bad connection with batteries.
Check connections, and recharge batteries.
1 • Scooter has entered ‘sleep’ mode to save battery life.
Switch the scooter off and on again to reset
2 • Very low battery voltage - Possible damaged battery/ies. Consult your
dealer if recharging fails or fault persists.
3 • Controller over-speed - over-voltage. Check battery connections.
Contact your dealer if the problem persists.
5 • Brake fault. Scooter left in freewheel or has a bad parking brake
connection. Engage drive, and switch scooter off and back on again. If
this fails to cure the problem, check parking brake and ensure it stops
the vehicle. Inform dealer who will check brake and motor connections.
6 • Throttle fault. Finger control levers must be in neutral (centred) position
before key is turned on. Switch scooter off, centre levers, and switch
back on. If fault persists, contact dealer.
7 • Speed potentiometer fault- Contact your dealer.
8 • Motor fault. Poor connection to motor or motor failure. Contact dealer.
9 • Possible controller trip - Switch off and back on again. Contact your
dealer if the problem persists.
Tip: If in doubt switch off and switch on – if this does not cure the fault contact your dealer. Your dealer is there to
help you but they can only do this if you give them as much information as possible. Remember correct
information will get the problem fixed quicker and save you money. Phone the dealer and explain exactly what the
problem is, recounting as much detail as possible. Tell them about the symbols & numbers appearing on the LCD
screen; this will help the engineer to identify the problem before he calls to fix it. Your dealer is there to help you.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rascal Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rascal Vision in the language / languages: English as an attachment in your email.

The manual is 1,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info