632982
10
Zoom out
Zoom in
Previous page
1/32
Next page
10 Rascal Vision Scooter Owner's Manual and Service Record
Freewheel Device
When the vehicle is switched off the brakes are automatically
e
ngaged. This is called “Failsafe Braking”. Also, if the batteries are
flat, the brakes are applied. There may be occasions where you may
wish to move the vehicle without power. To do this there is a
Freewheel Device fitted.
The Freewheel device allows the vehicle to be pushed without power.
To activate, first locate the lever. When standing behind the scooter, it
is located on the right hand side of the rear of the vehicle (see Fig 3)
Make sure the On/Off (ignition) key is in the off position.
Move the lever FORWARD The vehicle can now be pushed in Freewheel.
Move the lever BACK to engage drive. The vehicle is now braked. This is the normal operating position.
IF YOU ARE NOT COMPLETELY SURE OF THIS FEATURE CONTACT
YOUR DEALER BEFORE OPERATING THE SCOOTER.
NOTE: To avoid excessive strain on the tiller / handlebar assembly, never push or pull the scooter in
freewheel mode if a user is on-board. Push the lever FORWARDS to engage freewheel mode. Pull the lever
BACKWARDS to engage Drive mode.
Warning! If the freewheel device is in “freewheel” mode the braking is disabled. Never select the
freewheel mode if the Scooter is on a slope or could be pushed onto a slope.
Brakes
There are 3 braking systems. The first works with the finger controls. When the finger control is released the scooter
will automatically brake and bring the scooter to a stop. When the scooter stops the automatic parking brake will
engage. This will stop the vehicle rolling forward or backward. When you start the brake will automatically disengage.
If the battery should go flat the brakes automatically engage. Note that even when freewheel is selected, a secondary
regenerative braking system is applied automatically to limit the maximum speed. You may notice this system caus-
ing drag when moving the scooter in freewheel mode.
The third braking system is a state-of the-art twin hydraulic disc brake that can
be used in emergencies. This braking system is controlled by pulling/
compressing the lever on the right hand side of the handle bars/ tiller (see Fig 4).
The more pressure you apply to the lever the heavier the braking effect will be.
This braking system applies even braking to both back wheels making it one of
the safest designs on the market.
Tip: If you wish to lock this braking system on permanently to act as a
supplementary parking brake, you may do this by first pulling / compressing the lever and then move the locking
latch into position. When you release the lever it will stay compressed. Remember to always disengage the
locking latch before use by compressing the lever fully and rotaing the latch in the opposite direction.
4
3
Warning! Do not use the emergency brake for normal driving and never engage the lever locking latch
unless the scooter is stationery.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rascal Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rascal Vision in the language / languages: English as an attachment in your email.

The manual is 1,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info