661002
55
Zoom out
Zoom in
Previous page
1/198
Next page
en-53
7 OPERATION
Do not move pedal suddenly–always operate slowly and smoothly. Never move pedal violently from
forward to reverse or vice versa.
Always keep foot firmly on the foot pedal–a too relaxed foot control may result in a jerky motion.
7.8 MOWING _____________________________________________________________
1. Release the transport latches and lower the cutting units with the joysticks.
2. Ensure speed limiter is in mow position. (Cutting at a higher speed could be dangerous and may not give
the required finish.)
3. Engage the cutting mechanism by pushing on the lower half of cutting unit switch.
4. Release the parking brake and begin driving forward.
5. If the mower is used with the optional stability warning system a warning will be displayed on the visual
display unit on the control panel should the mower be driven on a slope exceeding its safe limit. At 22deg
the centre and upper unit will be raised 4"- 6" above the ground to improve stability and all units will stop
rotating. until the mower is moved to a safe operating area.
NOTE: Always set the throttle to full engine revs. for mowing, even when the grass is heavy. When the engine is
labouring, reduce forward speed by easing back on the FWD/REV foot pedal.
7.9 TO STOP THE ENGINE _________________________________________________
1. Disengage drive to the cutting units with the cutting unit switch.
2. Return the FWD/REV pedal to the neutral position.
3. Set the parking brake.
4. Move the throttle control lever to the SLOW position.
5. Turn the ignition key to OFF.
7.10 HOW TO REMOVE A BLOCKAGE FROM CUTTING UNITS ____________________
1) Disengage the power to the cutting units with the cutting unit switch.
2) Keep the cutting units lowered to the ground (Wait for the remaining cutting cylinders to stop rotation).
3) Lift the cutting units into the “Transport Position”, lock in position use the transport latches fitted on your
product.
CAUTION
It is important to note: there will be remaining hydraulic pressure within the system that can cause the cutting
cylinder to rotate when the obstruction is removed. Therefore keep your hands, feet and clothing away from
cutting units at all times.
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ransomes Highway 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ransomes Highway 3 in the language / languages: English, Dutch as an attachment in your email.

The manual is 27,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info