685842

RAINBIRD SUPER IMAGE SERIES Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
1 2 3 4 5 6 7
Prog A
Prog A
1 2 3 4 5 6 7
I. SET CLOCK
Icon : clock
A- Set the current time of day
Press the
key repeatedly until this display appears :
Now use the ON and OFF keys.
The time of day will appear in hours and minutes. The +/ON key increases
the setting. Holding down the key will cause the numbers to increase more
rapidly.The -/OFF key decreases the setting.
Note : 2 blinking dots separate the hours from the minutes.
B- Set current day
Press the key to move the square through the days of the week numbered 1 to 7 :
Monday = 1, Tuesday = 2,.....
Place the
square on the current day of the week . Example : if "today" is
Wednesday, place the square on "3".
II. SET DAYS OF THE WEEK TO WATER
Icon : calendar
Press the
key until this display appears :
First select the A or B program by pressing the A/B key. “Prog A” or
“Prog B” will appear in the upper left corner of the display.
Use the key to move the square through the days of the week (1 =
Monday). Note that the numbers blink.
The controller is factory pre-set to water every day. The +/ON and -/OFF
keys are used to set the water days. Press the OFF key if you do not wish to
water that day.
The square will disappear. If you change your mind, press the ON key and
the square returns.
Example : you want to water every Monday, Tuesday and Thursday. You
must therefore cancel the days you do not wish to water.
Use the key to move the square to day 3. Now press the OFF key. The
square around the number 3 = Wednesday will disappear. Repeat the procedure for Friday, Saturday and Sunday
(numbers 5, 6 and 7). In this example, only numbers 1, 2 and 4 should appear within a square.
III. SET START TIMES
Icon : alarm clock
You may operate the same cycle up to 8 times a day. At each “start time”, all stations on a program will operate in
sequence for the duration you have selected. See chapter IV.
Now you set the start times for each of the programs.
Repeatedly press the
key until this display appears :
Use the A/B key to select program A or B. The program selected is
indicated on the display by “prog” followed by A or B.
Now set the first start time.
Use the +/ON and -/OFF keys to increase or decrease the setting.
After setting the first start time, press to set the next start time. Use the
+/ON and -/OFF keys.
To set the start times for the other program, press the A/B key.
To store the starts and move to the next function use the
key.
Note : it is not necessary to use all the start times !
The SUPER IMAGE controller will automatically file your start times in
chronological order (from 00.00 to 23.59).
To cancel a start time : repeatedly press the key to display the start times. When you see the start time you want to
cancel, hold down the key for at least 2 seconds.
Note : There is only 1 dot between hours and minutes for start times.
2


Need help? Post your question in this forum.

Forumrules
1

Forum

rainbird-super-image-series

Reset search

  • Good morning. I have IMAGE 4. I have imposted a new program for four stations. After done first station there aren't daai for another statons. All the data imposted are cancelled. Thanks you Submitted on 1-8-2023 at 15:17

    Reply Report abuse

  • i need a new float valve in the tank and can't find one. and one of the spray units is leaking Submitted on 5-8-2022 at 16:33

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for RAINBIRD SUPER IMAGE SERIES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of RAINBIRD SUPER IMAGE SERIES in the language / languages: English as an attachment in your email.

The manual is 0,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info