570007
6
Zoom out
Zoom in
Previous page
1/36
Next page
Preparation
6
When deciding on an outdoor antenna and its location,
consider these points:
The antenna should be located as high as possible.
The antenna and antenna cable should be as far as
possible from sources of electrical noise (appliances,
other radios, and so on).
The antenna should be vertical for the best
performance.
To connect an optional base-station or mobile antenna, first
remove the supplied antenna from the scanner. Always use
50 Ohm coaxial cable, such as RG-58 or RG-8, to connect
an outdoor antenna. For distances longer than 50 feet, use
RG-8 low-loss dielectric coaxial cable. If the antenna cable's
connector does not have a BNC connector, you will also
need a BNC adapter (not supplied, available at your local
RadioShack store). Your local RadioShack store carries a
wide variety of coaxial cable and connectors.
Once you choose an antenna, follow the mounting
instructions supplied with the antenna. Then route the
antenna's cable to the scanner and connect the cable to the
ANT connector.
.
%100'%6+0) "#0"'#42*10'1
*
'#&2*10'5
For private listening, you can plug a
1
/
8
-inch (3.5-mm) mini-
plug earphone or headphones (not supplied), available at
your local RadioShack store, into
/PC
on the back of the
scanner. This automatically disconnects the internal
speaker.
.KUVGPKPI"5CHGN[
To protect your hearing, follow these guidelines when you
use an earphone or headphones.
Set the volume to the lowest setting before you begin
listening. After you begin listening, adjust the volume to
a comfortable level.
Do not listen at extremely high volume levels. Extended
high-volume listening can lead to permanent hearing
loss.
Once you set the volume, do not increase it. Over time,
your ears adapt to the volume level, so a volume level
that does not initially cause discomfort might still
damage your hearing.
R
"9#40+0)"
R
"
Use extreme caution when
installing or removing an outdoor
antenna. If the antenna starts to
fall, let it go! It could contact
overhead power lines. If the
antenna touches a power line,
touching the antenna, mast, cable,
or guy wires can cause
electrocution and death. Call the
power company to remove the
antenna. DO NOT attempt to do
so yourself.
.
"%#76+10"
.
Do not run the cable over sharp
edges or moving parts that might
damage it.
20-424.fm Page 6 Monday, September 9, 2002 9:44 AM
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for RadioShack PRO-2018 - 200 Channel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of RadioShack PRO-2018 - 200 Channel in the language / languages: English as an attachment in your email.

The manual is 1,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info