713880

Quickie Xenon 2 FF Manual

28
Zoom out
Zoom in
Previous page
1/92
Next page
ENGLISH
XENON 2 FF 28 Rev.4.0
6.11 Crutch Holder
Crutch holder
This device permits crutches to be transported directly on
the wheelchair. It has a Velcro loop to fasten crutches or
other aids, (Fig.6.11.1).
WARNING!
Never try to use or remove the crutches or other aids
while moving.
6.12 Anti-Tip Tubes
WARNING!
Sunrise Medical recommends anti-tip tubes are fitted for
all chairs.
When fitting anti-tip tubes, use a torque of 7 Nm.
Anti-tip tubes prevent the wheelchair from tipping
backwards, providing additional safety for new users and
for users familiarising themselves with the operation of
the wheelchair.
Plug in Type
Slotting the anti-tip tubes into the clamp
• Press the rear button on the adapter for the anti-tip
tube in such a way that both release pins are pulled
inwards.
• Slot the anti-tip tubes (1) into the anti-tip tube adapter.
• Rotate the anti-tip tubes downwards, until the release
pin clicks into place in the clamp.
• Fit the second anti-tip tube in the same way.
Adjusting the anti-tip tubes
To achieve the correct ground clearance of approximately.
1“ to 2“ (25 mm to 50 mm), the anti-tip tubes must be set
higher or lower:
• Push the release lever for the anti-tip tube in such a
way that both release pins are pulled inwards.
• Move the inner tube upwards or downwards in the
height-adjustment holes.
• Release the button.
• Fit the second anti-tip tube in the same way.
• Both wheels must be at the same height. (Fig.6.12.1).
Fig.6.11.1
Fig.6.12.1
1
Fig.6.12.2
1
Swing-away Type
Push down on the top of the anti-tip tube, (1), to bring
them into position, (Fig.6.12.2).
A 30 - 50 mm gap should be maintained between the anti
tip wheels and the ground.
The anti-tips can also be swung into a forwards position.
The anti-tips must always be in the forward position when
negotiating large obstacles, (such as kerbs), to prevent
them from interfering with the manoeuvre.
DANGER!
If the anti-tip tubes are not fitted, or have been fitted
incorrectly, there is a risk of tipping over and of injury.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quickie Xenon 2 FF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quickie Xenon 2 FF in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 2,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info