Manual Quickie Argon 2 (page 22 of 72) (English, Dutch, French)

713882

Zoom out

Zoom in

1/72

ENGLISH

Argon

Rev.1.0

Fig. 4.43

The lap belt should be fixed so that the belt sits at an

angle of 45 degrees across the users pelvis. The user

should be upright and be as far back as possible in the

seat when correctly adjusted. The lap belt should not

allow the user to slip down in the seat.

(Fig. 4.44)

To fasten buckle:

Firmly push male buckle

into female buckle.

To release belt:

Press exposed sides of

male buckle and push

towards centre whilst gently

pulling apart.

WARNING !

• If in doubt about the use and operation of the lap belt

then ask your healthcare professional, wheelchair

dealer, carer or attendant for assistance.

• The lap belt must only be fitted by an approved

Sunrise Medical dealer / agent.

• The lap belt should only be adjusted by a

professional, or a Sunrise Medical approved dealer /

agent.

• The lap belt must be checked on a daily basis to

ensure it is adjusted correctly and free from any

obstruction or adverse wear.

• Sunrise Medical does not encourage the

transportation of any person in a vehicle using this

lap belt as a method of restraint.

Please see Sunrise Medical transit booklet for

further advice on transportation.

Maintenance:

Check lap belt, and securing components, at regular

intervals for any sign of frays or damage. Replace if

necessary.

WARNING

The lap belt should be adjusted to suit the end user as

detailed above. Sunrise Medical recommend that the

length and fit of the belt be checked on a regular basis to

reduce the risk of the end user inadvertently re-adjusting

the belt to an excessive length.

Fig. 4.44

5.0 Tyres and Mounting

Solid rubber tyres are standard.

With pneumatic tyres always make sure that the tyres

have the correct air pressure, as otherwise the

performance of the wheelchair may be affected. If the tyre

pressure is too low, rolling resistance will increase,

requiring more effort to move the chair forward. Low tyre

pressure also has a negative impact on manoeuvrability. If

the tyre pressure is too high, the tyre could burst. The

correct pressure for a given tyre is printed on the surface

of the tyre itself.

Tyres are mounted the same way as an ordinary bicycle

tyre. Before installing a new inner tube, you should always

make sure that the base of the rim and the interior of the

tyre are free of foreign objects. Check the pressure after

mounting or repairing a tyre. It is critical to your safety and

to the wheelchair’s performance that regulation air

pressure be maintained and that tyres be in good

condition.

6.0 Maintenance and care

• Check the tyre pressure every 4 weeks. Check all tyres

for wear and damage.

• Check the brakes approximately every 4 weeks to make

sure that they are working properly and are easy to use.

• Change tyres as you would an ordinary bicycle tyre.

• All of the joints that are critical to using your wheelchair

safely are self-locking nuts. Please check every three

months to make sure that all bolts are secure (see the

section on torque). Safety nuts should only be used once

and should be replaced after use.

• Please use only mild household cleansers when your

wheelchair is dirty. Use only soap and water when

cleaning the seat upholstery.

Anteria Lateral Support (Lap belt)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Quickie Argon 2 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Quickie Argon 2 Manual

Product: