815524

Quadra-Fire Classic Bay 1200 Pellet Manual

18
Zoom out
Zoom in
Previous page
1/40
Next page
18 7027-802M 04/23
C. General Maintenance and Cleaning
1. Types of Fuel
The type of fuel you are burning will dictate how often you
have to clean your re pot.
If the fuel you are burning has a high dirt or ash content, it
may be necessary to clean the re pot more than once a
day.
Dirty fuel will cause clinkers to form in the repot
(Figure 18.1). A clinker is formed when dirt, ash or a
non-burnable substance is heated to 2000°F (1093°C)
and becomes glass-like. See High Ash Fuel Content
Maintenance on page 22 for more details on di󰀨erent types
of fuels.
Back side of Firepot
Firepot floor left open
Figure 18.2
Clinker
Figure 18.1
NOTE: If you are just cleaning the re pot, there is no
need to unplug the insert.
3. Ash Removal from Firebox
• Frequency: Every 5 bags or weekly or more frequently
depending on ash build-up.
• By: Homeowner
a. There must not be any hot ashes in the rebox during
cleaning so allow the appliance to completely cool.
The rebox ash should be removed every time the
exhaust path is cleaned. Frequent cleaning of the
ash in the rebox will help slow down the build-up of
ash in the exhaust blower and vent system.
b. Plug in your appliance, if unplugged, and turn the
thermostat on and immediately shut it o󰀨 to start the
exhaust blower on its cycle time. It will pull y ash out
the exhaust instead of into the room.
c. Open door. Remove ash with an ash vacuum or whisk
broom and small dust pan.
d. This ash is deposited in the same ash pan as the re
pot debris. The ash pan should be emptied every time
you clean the rebox. Remember to place the ash
and debris into a metal or noncombustible container.
e. The cleaning rods must be fully closed when cleaning
is complete; see Disposal of Ashes on page 19.
4. Cleaning Ash Pan
• Frequency: Weekly or every 5 bags of fuel
• By: Homeowner
Empty into a non-combustible container and re-install ash
pan; see Disposal of Ashes on page 19.
b. Pull re pot cleaning rod OUT a couple of times to
help shake debris loose. If rod is hard to pull, it may
be necessary to use your re pot clean-out tool to
chip away material that has built up on the bottom
plate of the re pot and to push out any clinkers.
Larger clinkers may have to be removed from the top
of the re pot.
c. The re pot oor plate must be fully closed when
nished (Figure 18.2).
2. Cleaning Fire pot with Cleaning Rod & Fire pot
Scraper
• Frequency: Daily or more often as needed
• By: Homeowner
a. The appliance must be in complete shutdown and
cool and the exhaust blower o󰀨.
WARNING
Fire Risk
• NEVER pull re pot cleaning rod or
cleaning slide plates out when appliance
is operating.
• The cleaning slide plates must be fully
CLOSED when appliance is operating.
• Hot pellets may fall into ash pan and start a re or
mis-starts due to lack of vacuum.
Fire Risk
• The cleaning slide plates must be fully
CLOSED when appliance is operating.
Hot pellets may fall into ash pan and start
a re.
WARNING
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Classic Bay 1200 Pellet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 Pellet in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info