572608

Pulsar Apex XD38 Manual

5
Zoom out
Zoom in
Previous page
1/55
Next page
6
7
5
6
Controller:
Rotation (by default) – display brightness adjustment
Short press – switching between brightness and contrast adjustment modes,
gradual digital zoom.
Rotation (followed by a short press) – display contrast adjustment
Rotation (followed by a short press) – continuous digital zoom (from 1x to 2x
with 0.1x increment)
Long press – entering the menu.
MENU/STATUS BAR ICONS
Operation mode “Rocks“
Operation mode “Forest”
Operation mode “Identification”
Manual calibration
Semiautomatic calibration
Automatic calibration
PAL/NTSC video output signal selection / disable
Clock setup
Brightness control of onscreen symbols
2x continuous digital zoom
Defective pixel repair option
Cross for defective pixel repair
Display brightness and contrast adjustment
Image inversion mode: “White hot”/“Black hot”
Return to default settings
Low battery indicator
Operation on external power supply
Please refer to section 11 “Main menu” for other icons.
GUIDELINES FOR OPERATION
The sight has been designed for long-term use. To ensure sustainable
performance, please adhere to the following:
џ Before use make sure that you have installed and fixed the mount
according to the instructions of the section “Installation of mount” (section
9 “Operation”).
џ Store with the lens cap on in the carrying case.
џ Switch off the scope after use.
џ Attempts to disassemble or repair the scope will void the warranty!
џ Clean the scope's optical surfaces only if necessary, and use caution. First,
remove (by blowing with a blower brush or canned air) any dust or sand
particles. Then proceed to clean by using camera/lens cleaning equipment
approved for use with multicoated lenses. Do not pour the solution directly
onto the lens!
џ The sight can be used in various operating temperatures. However, if it has
been brought indoors from cold temperatures, do not turn it on for 2 to 3
hours. This will prevent external optical surfaces from fogging.
џ If the sight is unable to mount onto the rifle securely, or you have doubts
about the mounting system, see a qualified gunsmith. Using the weapon
with a poorly mounted scope can lead to inaccurate target shooting!
џ To ensure reliable performance, it is recommended to carry out regular
technical inspections of the unit.
џ Do not leave batteries in the unit if it is not going to be used for an extended
period.
џ Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
WARNING! Do not point the objective lens of the unit at bright sources of
light such as the sun. This may disable electronic components of the unit.
The warranty does not cover damage caused by improper operation.
BATTERY INSTALLATION
џ Turn the battery compartment knob (4) counterclockwise to the “Open”
position and remove it.
џ Install two CR123A batteries (or rechargeable batteries) according to the
marking on the battery compartment cover and inside it.
џ Turn the battery compartment knob (4) clockwise – the latch will pull out
(see the drawing).
џ Replace the battery cover and press it until its clicking position - the cover
will close.
џ Battery charge level is displayed on the status bar ( ) .
џ In case of complete battery discharge, icon is flashing on the status bar
and in the centre of the display.
Note: to ensure long and reliable operation it is recommended that you use
quality rechargeable batteries 16340 (CR123A) with a capacity of at least
800 mAh. Please do not use batteries of different types or batteries with
various charge levels.
7
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pulsar Apex XD38 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pulsar Apex XD38 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info