519093

Prophete 0516 Manual

7
Zoom out
Zoom in
Previous page
1/32
Next page
A
B
C
D
E
A
A
E
A
B
B
E
E
3. Display and function keys
4. Assembly
4.1 Bicycle computer mount and bicycle computer
Attach the bicycle computer mount (A) to the handlebars using the cable ties
(E). Insert the bicycle computer into the bicycle computer mount from the
front until it engages. Then turn the bicycle computer to the desired viewing
angle. Press down on the catch to remove the bicycle computer.
Table of contents
1. Scope
2. Safety and maintenance
2.1 Safety instructions
2.2 Repairs
2.3 Operating environment conditions
2.4 Ambient temperature
2.5 Electromagnetic compatibility
2.6 Battery operation
2.7 Disposal
2.7.1 Battery disposal
2.7.2 Bicycle computer disposal
2.7.3 Packaging disposal
2.8 Maintenance
2.9 Cleaning and care
2.10 Storage
2.11 Notes to these operating instructions
2.12 Scope of delivery
3. Display and function keys
4. Assembly
4.1 Bicycle computer mount and bicycle computer
4.2 Mounting the sensor
5. Initial operation
5.1 Switching on the bicycle computer for the fi rst time
5.2 Setting the wheel size
5.3 Selecting KM - Miles
5.4 Setting the inspection interval
5.5 Setting the 12/24-hour display
5.6 Setting the clock
5.7 Bicycle computer check
5.8 New start/Reset
5.9 Automatic start/stop
6. Modes/Functions
6.1 Resetting the route data to zero
6.2 Resetting the maximum speed to zero
6.3 Manual entry of total kilometres
7. Battery replacement
7.1 Bicycle computer
8. Declaration of Conformity
9. Description of fault
10. Warranty provisions
1. Scope
This bicycle computer has been designed for sole use as a bicycle computer.
Bicycle computers supply information about the speed and covered distanc-
es. Any other use than described in these operating instructions is not per-
mitted and can cause damage and injuries. We shall not assume liability for
damage due to improper use. You will fi nd further notes and explanations in
the operating instructions.
2. Safety and maintenance
2.1 Safety instructions
Please read this chapter carefully and comply with all given notes. This guar-
antees reliable operation and the long service life of your bicycle computer.
Please keep the packaging and the operating instructions in a safe place in
order to pass them on to a new owner should you sell the bicycle computer.
Never open the housing of the bicycle computer and the sensor, as it does
not contain any parts requiring maintenance (opening the battery compart-
ment to insert or replace the batteries, see Point 7, Battery replacement, is
the exception). Do not place any objects on the bicycle computer and do not
exert pressure on the display. This could otherwise damage the display. Do
not touch the display with square-edged objects to avoid damage.
2.2 Repairs
In case of necessary repairs or a technical problem, please consult our
Service Centre. You will fi nd the address in Point 10, Warranty provisions.
2.3 Operating environment conditions
The bicycle computer is splash water protected. Make sure your bicycle
computer is not exposed to moisture or continuous high humidity and avoid
dust, heat and extended periods of direct sunlight. Non-compliance with
these notes can cause faults or damage to the bicycle computer.
Issue 05/2009
2.4 Ambient temperature
The bicycle computer can be permanently operated and stored at ambient
temperatures of -10°C to 50°C.
2.5 Electromagnetic compatibility
If possible, do not use the bicycle computer in close proximity to, e.g. com-
puters, printers, television sets, mobile phones or radios, as devices with
strong EMC radiation can cause interference.
2.6 Battery operation
Your bicycle computer is operated by a 3V/CR2032 battery. In the following
you will fi nd a few notes on how to handle batteries:
Replace the battery only with an equivalent battery type. Batteries may not
be charged or reactivated using other means, may not be taken apart,
thrown into fi re or short-circuited. Always keep the battery out of the reach of
children. Batteries can be fatal if swallowed. Therefore, keep the battery and
the bicycle computer out of reach of small children. Seek medical assistance
immediately if a battery was swallowed. If required, use a slightly moist cloth
to clean the device and battery contacts and dry thoroughly before inserting
the batteries. Be careful with leaked batteries! Avoid contact with skin, eyes
and mucous membranes! If contact was made with battery fl uid, immediately
rinse the aff ected spot with plenty of water and consult your doctor directly.
Batteries cannot tolerate heat. Make sure to prevent the computer and its in-
serted batteries from becoming too hot. Disregarding these notes can lead
to damage and even cause the batteries to explode. Temperatures below 0 °C
can have a negative eff ect on the battery life. You will fi nd information on how
to replace the batteries in Point 7, Battery replacement.
2.7 Disposal
2.7.1 Battery disposal
Batteries are hazardous waste. To properly dispose of the batteries,
stores selling batteries and municipal collection points have provided
corresponding containers.
2.7.2 Bicycle computer disposal
If you would like to get rid of your bicycle computer, dispose of it as per
current regulations. Information can be obtained from the municipal offi ce.
2.7.3 Packaging disposal
Dispose of the bicycle computer packaging as per current regulations.
Information can be obtained from the municipal offi ce.
2.8 Maintenance
2.9 Cleaning and care
Only clean the bicycle cyclometer with a soft, moistened, lint-free cloth. Do
not use any solvents, corrosive or gaseous cleansing agents. Make sure that
water droplets do not remain on the display. Water can cause permanent dis-
colouration. Do not expose the bicycle computer display to fi erce sunlight or
ultraviolet radiation.
2.10 Storage
Remove the battery if you will not use the bicycle computer for an extended
period of time. To store the bicycle computer, please observe the notes in
Point 2.3 Operating environment conditions, and Point 2.4 Ambient tempera-
ture. The bicycle computer should be stored securely. Avoid high tempera-
tures (e.g. direct sunlight) and a permanently moist environment.
Note:Please position the bicycle computer so that it is not exposed to
extreme heat or cold. Extreme colds weakens the batteries and thus the
transmission signal. (see 2.4)
2.11 Notes to these operating instructions
We have structured the operating instructions for this bicycle computer so
that you can consult the table of contents to fi nd the required, relevant infor-
mation at any time. If you have any further questions, you can also contact us
using the following address:
Service address: Prophete GmbH u. Co. KG
Lindenstrasse 50
D-33378 Rheda-Wiedenbrück, Germany
05242-4108-59
E-mail address: service@prophete.net
2.12 Scope of delivery
Bicycle computer
A = Bicycle computer mount
B = Sensor
C = Magnet with screw
D = 3V battery CR2032 for bicycle computer
E = Cable ties
Caution! There are no parts that need to be maintained or cleaned inside
the housing of the bicycle computer.
LEFT key RIGHT key
4.2 Mounting the sensor
Attach the sensor (B) with cables ties (E) below the bicycle computer on the
fork, as illustrated in the following fi gure. Make sure to lay the cable in such a
way that it is not pulled too tight or rips when you turn the handlebar and
make sure that it cannot get caught in the spokes of the front wheel while rid-
ing. Fix with a cable tie (E) as necessary. Place the magnet on a spoke of the
front wheel and attach with the screw (C). Make sure that the magnet is
aligned with the sensor. With 2 mm clearance as illustrated in the next fi gure.
Clearance to magnet 2 mm
5. Initial operation
We recommend carefully reading the operating instructions fi rst before
putting the bicycle computer into operation.
5.1 Switching on the bicycle computer for the fi rst time
A few settings must be made before the bicycle computer can be used for
the fi rst time. Press the LEFT or RIGHT key to switch on the bicycle computer.
The fi rst item to appear is the entry for the wheel size "2124".
BA_Fahrrad_PC_0516_GB.indd 9-16BA_Fahrrad_PC_0516_GB.indd 9-16 25.05.2009 13:24:38 Uhr25.05.2009 13:24:38 Uhr
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Prophete 0516 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Prophete 0516 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 6,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info